Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Catalytic Oxidation of Chlorobenzene over V2o5/Tio2-Carbon Nanotubes Composites

Catalytic Oxidation Of Chlorobenzene Over V2o5/Tio2-Cnts Nano Composites

Catalytic Decomposition of 1,2-Dichlorobenzene over V2O5/TiO2 Catalysts Blending with Typical Carbon Nanotubes

Low temperature chlorobenzene catalytic oxidation over MnOx/CNTs with the assistance of ozone

Catalytic Oxidation of 1,2-Dcbz over V2O5/TiO2-CNTs: Effect of CNT Diameter and Surface Functional Groups.

Catalytic Oxidation of Chlorobenzene over Mnox/Al2o3-Carbon Nanotubes Composites

Low-temperature Catalytic Oxidation of Chlorobenzene over MnOX/TiO2–CNTs Nano-Composites Prepared by Wet Synthesis Methods

Influence of Functionalized Carbon Nanotubes on Catalytic Activity of V<sub>2</sub>O<sub>5</sub>/TiO<sub>2</sub>‐CNTs for 1, 2‐Dichlorobenzene Oxidation

Influence of Functionalized Carbon Nanotubes on Catalytic Activity of V 2 O 5 /TiO 2 ‐CNTs for 1, 2‐Dichlorobenzene Oxidation

Catalytic Degradation of 1,2-Chlorobenzene and Dioxins Coupled by Kinds of Methods

Catalytic Oxidation of 1,2-Dichlorobenzene on V2O5–WO3/TiO2 Films: Effects of Ozone Addition and UV Irradiation

Catalytic Oxidation of Chlorobenzene over Ce-Mn-Ox/TiO2: Performance Study of the Porous Structure

Ozone Assisted Oxidation of Gaseous PCDD/Fs over CNTs-containing Composite Catalysts at Low Temperature.

Ozone Promotion of Monochlorobenzene Catalytic Oxidation Over Carbon Nanotubes-Supported Copper Oxide at High Temperature

Catalytic Oxidation of 1,2-Dcbz over V<SUB Align="right">2o<sub Align="right">5/tio<sub Align="right">2-Cnts Catalysts: the Effect of Water

Catalytic Combustion of VOCs on Pt/CuMnCe and Pt/CeY Honeycomb Monolithic Catalysts

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Catalytic conversion of 1,2-dichlorobenzene (1,2-DCBz) over V2O5/TiO2-based catalysts

Preparation of MnOx/TiO2 composites and their properties for catalytic oxidation of chlorobenzene.

Promotional Effects of Carbon Nanotubes on V2O5/TiO2 for NOX Removal.

Confined Cobalt on Carbon Nanotubes in Solvent‐free Aerobic Oxidation of Ethylbenzene: Enhanced Interfacial Charge Transfer