Abstract:In this paper, a servo motor operated rotary directional control valve is proposed, and a systematic analysis of steady flow torques in this valve is provided by theoretical calculation, CFD simulation and experimental test. In the analysis, spool rotation angle corresponding to the maximum orifice opening is tagged as 0 degrees. Over a complete change cycle of the orifice, the range of spool rotation angle is symmetric about 0 degrees. The results show that the direction of steady flow torques in this valve is always the direction of orifice closing. The steady flow torques serve as resistances to the spool rotation when the orifice opening increases, while impetuses to the spool rotation when the orifice opening decreases. At a certain pressure drop or flow rate, steady flow torques are approximately equal and opposite when at spool rotation angles which are symmetric about 0 degrees. When the spool rotates from 0 degrees, at a certain pressure drop, their values increase first then decrease with the spool rotation and reach their maximum values at an angle corresponding to about 1/2 of the maximum orifice opening, and at a certain flow rate, their values increase with the spool rotation. The steady flow torques in this valve are the sums of those in the meter-in and meter-out valve chambers. At a certain spool rotation angle, steady flow torques in the meter-in and meter-out valve chambers are approximately proportional to the pressure drop and the second power of the flow rate through the orifice. Theoretical calculation and CFD simulation can be validated by the experimental test. The proposed calculation formulas can predict the steady flow torques in the rotary directional control valve correctly. (C) 2015 Elsevier Ltd. All rights reserved.

Study on amendment of orifice equation for small spool displacement and application

Steady Flow Torques in a Servo Motor Operated Rotary Directional Control Valve

Mathematical model and experimental verification of high flow cartridge servo valve

Comparing research on two different numerical models of electrostatically actuated valveless micropump

Design and modeling of precise flux valve driven by piezoelectric ceramics

Flow field simulation and establishment for mathematical models of flow area of spool valve with sloping U-shape notch machined by different methods

Experimental and Numerical Investigation of Flow Forces in a Seat Valve Using a Damping Sleeve with Orifices

Numerical and Experimental Investigation on Opening Direction Steady Axial Flow Force Compensation of Converged Flow Cartridge Proportional Valve

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

Flow Rate Adjustable Ratio Analysis of a Novel Control Valve with Double Sleeve

Computational fluid dynamics analysis on orifice structure inside valve core of pilot-control angle globe valve

Numerical Study On Temperature Field And Spool Deformation Of Throttle Slide Valve With V-Notches

Waveforms Analysis and Optimization of New Electro-Hydraulic Excitation Technology

Structure Optimization of Conical Spool and Flow Force Compensation in a Diverged Flow Cartridge Proportional Valve

Reduction of Steady Flow Torques in a Single-Stage Rotary Servo Valve

Static and Dynamic Performance Improvement of a Hydraulic Feedback Valve for Load Control by Introducing Force Feedback and Compensation Orifice

Numerical Simulation and Structure Improvement of Double Throttling in A High Parameter Pressure Reducing Valve

Numerical Investigation of Cavitation Flow Inside Spool Valve with Large Pressure Drop

Numerical Study on Sealing Performance after Wear of Plug Valve During Opening–closing Process

Research on the Factors That Affect the Throttling Mouth Flow Coefficient of Spool Valve

Effects of Orifice on Pressure Difference in Pilot-Control Globe Valve by Experimental and Numerical Methods