Abstract:Printhead heating is implemented during aerosol jet printing to drive aerosol‐phase drying, supporting higher throughput fabrication with minimal change in resolution. This reduces process sensitivity, provides an effective and independent control to tailor print characteristics that generalizes to different inks, and is particularly useful for challenging print requirements such as conformal and high aspect ratio patterning. Aerosol jet printing offers high resolution, broad materials compatibility, and digital patterning for flexible, conformal, and hybrid electronics. However, limited throughput, instability, and complex optimization requirements inhibit translation to industrial applications. An in‐line heater integrated on a custom printer is demonstrated to modulate droplet evaporation in the aerosol phase, thereby decoupling the deposition rate of functional solids and liquid ink to enable taller, narrower features with aspect ratios reaching 0.29 for a single line. Heating the printhead from room temperature to 80 °C reduced the sensitivity of resolution to deposition rate by ≈90%, improving reliability. With this strategy, increasing the linear deposition rate by 10x results in a modest increase of 27% in line width, compared to a four‐fold increase without heating, permitting higher throughput without sacrificing print quality. Providing a control for in‐line drying independent of ink formulation enables rapid, straightforward design of new materials and processes. This ability to engineer drying of droplets prior to impingement provides a versatile tool to meet complex fabrication challenges, as demonstrated here for both high aspect ratio printing and conformal patterning on rough and three‐dimensional surfaces.

Characteristics of Carbon Nanotubes Based Micro-Bubble Generator for Thermal Jet Printing.

Characteristics of carbon nanotube based micro-bubble generators for thermal jet printing

A Thermal Ink-Jet Printer Head Prototype with Full Carbon Based Microbubble Generator

Leveraging 3D Printing for the Design of High-Performance Venturi Microbubble Generators

Inkjet Printhead Arrays with No Separating Wall Between Bubbles

Carbon nanotubes as heating elements for micro-bubble generation

Micro-Bubble Generation With Micro-Watt Power Using Carbon Nanotubes Heating Elements

Analysis on electro-thermal property of micro-bubble generator using carbon nanotube heating elements

Structural Design and Performance of a Jet-Impinging Type Microbubble Generator

Microbubble Generation Using Carbon Nanotubes Heating Elements

High efficiency micro-bubble generator using carbon nanocoils as heater

Design and Fabrication of A Piezoelectric Bend Mode Drop-On-Demand Inkjet Printhead with Interchangeable Nozzle

Enhanced Resolution, Throughput, and Stability of Aerosol Jet Printing via In Line Heating

Fabrication and Evaluation of a Protruding Si-based Printhead for Electrohydrodynamic Jet Printing

Vorticity-induced flow-focusing leads to bubble entrainment in an inkjet printhead: synchrotron X-ray and volume-of-fluid visualizations

Fabrication and electrical characteristics of carbon nanotube-based microcathodes for use in a parallel electron-beam lithography system

Droplet Jetting of Piezoelectric Printhead and Corresponding Effect Factors

Design and Fabrication of Monolithic Multidimensional Data Registration Cmos/Mems Ink-Jet Printhead

Experimental Investigation of CNT-Based Micro Bubble Generation Inside Microchannels

A Simple Method for Fabricating Ink Chamber of Inkjet Printheads

Design and Fabrication of a PET/PTFE-based Piezoelectric Squeeze Mode Drop-on-demand Inkjet Printhead with Interchangeable Nozzle