Abstract:Micro-channel cooler is a very promising approach to meet the requirements of microelectronics package cooling. A lot of investigations about micro-channels have been undertaken in the past years. A silicon micro-channel can remove 790W/cm2 heat with a temperature rise of 71 degrees between the substrate and the coolant. The width and height of the silicon channel are 50um and 302um separately [1]. However, as the trends in the electronics industry moves towards higher packaging density, the high-pressure drop problem limits the performance of traditional silicon heat sink. Replacing the silicon fins with nanotube fins to enhance the thermal exchange rate between cooling liquid and substrate is one way to overcome this problem. Growing aligned nanotubes on the whole substrate is another one [2]. Carbon nanotubes (CNTs) are a new form of carbon which was discovered in 1991 by Iijima [3]. CNTs can be grown directly on the surface of silicon accurately according to predefined small-scale catalyst patterns normally transferred by standard photolithography processes. It was reported that nanotubes have an extremely high thermal conductivity over 3000W/(km) [4], so in the present work, the thermo physical properties of CNTs are obtained via molecular dynamics (MD) method. Fig. 1 shows one single-wall CNT simulation by LAMMPS. Several CNTs-fin heat sinks (1cm*1cm) with different fin width varied from 2um to 200um are tested (Fig. 2). Then the aligned CNTs heat sink is also simulated to compare with the long CNTs-fin model. The heat transfer coefficients and pressure drop of these structures are computed. Results indicate replacing the silicon-fin with CNTs-fin is a promising method and the long CNT-fin model shows better performance than the aligned CNTs for generating little pressure drop. Among the models, the best one is chosen for experiments in next work.

Analysis on electro-thermal property of micro-bubble generator using carbon nanotube heating elements

Structural Design and Performance of a Jet-Impinging Type Microbubble Generator

Quantitative Thermal Imaging of Single-Walled Carbon Nanotube Devices by Scanning Joule Expansion Microscopy.

Thermal Management for Purification of Aligned Arrays of Single-Walled Carbon Nanotubes Based on Thermocapillary Flow by Pulsed Heating

Microheater Chips with Carbon Nanotube Resistors

Modeling of thermocapillary flow to purify single-walled carbon nanotubes

Development of microbubble generation method

Thermal Bubble Nucleation in a Nanochannel: an Experiment Investigation

Mixed Convection and Entropy Generation Analysis of Carbon Nanotube-Water Nanofluid in a Square Cavity with Cylinders and Flow Deflectors

The Interface Effect Of Carbon Nanotube Suspension On The Thermal Performance Of A Two-Phase Closed Thermosyphon

Design and Test of Carbon Nanotube Biwick Structure for High-Heat-Flux Phase Change Heat Transfer

Liquid–Solid Triboelectric Probes for Bubbles Status Monitoring

Enhancement of Natural Convection by Carbon Nanotube Films Covered Microchannel-Surface for Passive Electronic Cooling Devices.

The motion mechanism and characteristic of bubble in a pseudo-2D tapered fluidized bed

Regulatable Thermal Conductivity and Excellent Mass Transport of Water-Filled Carbon Nanotube As Capillary Wicks

Carbon Nanocoil-Based Photothermal Conversion Carrier for Microbubble Transport

Enhancement of Evaporative Heat Transfer on Carbon Nanotube Sponges by Electric Field Reinforced Wettability

Improved Performance of Heat Source Free Water‐Floating Carbon Nanotube Thermoelectric Generators Controlling Wettability Using Atmospheric‐Pressure Plasma Jet and Waterproof Spray

Thermal Characterization of Microscale Heat Convection under Rare Gas Condition by a Modified Hot Wire Method

Package heat dissipation with integrated carbon nanotube micro heat sink

Heat Transfer and Visualization of Flow Boiling on Nanowire Surfaces in the Microchannel