Abstract:Quenching experiments were performed with hot stainless steel spheres in a pool of water-based nanofluids in the presence of carbon nanotubes (CNTs) of various sizes. In order to explore the size effect, a test matrix was developed by choosing multi-walled CNTs with lengths from 1 μm to 5 μm and outer diameters from 30 nm to 60 nm. The concentration was fixed at 0.5% by mass for all types of CNTs. The initial temperature was 400 °C and the transient temperature variations at the center of the sphere were recorded as quenching curves. By establishing a lumped capacitance model, the transient surface heat flux variations were obtained as boiling curves. The original and boiled surfaces were both subjected to a series of characterizations to determine the changes in morphology, roughness, and wettability to identify the effects of CNT size on the surface properties of the formed deposition layers as well as to elucidate the mechanisms for regulation of the boiling and quenching behaviors. The results suggested that the critical heat flux (CHF) and the Leidenfrost point (LFP) are enhanced to various degrees due to the discrepancy in the size of the CNTs in nanofluids. It was shown that the CNTs deposited on the surfaces create various morphologies depending on their size. The CNTs with a length of 5 μm and a diameter of 60 nm exhibited the most significant effect on the boiling behaviors. In comparison to CNTs with a shorter length of 1 μm, the 5 μm long CNTs were much easier to form porous layers. The results of the contact angle and roughness tests showed that the porous layers tend to affect the surface roughness instead of surface wettability. The increases of the nucleation site density and surface roughness due to the presence of porous layers were identified as the primary cause for the modified boiling behaviors during quenching.

The Interface Effect Of Carbon Nanotube Suspension On The Thermal Performance Of A Two-Phase Closed Thermosyphon

Boiling characteristics of carbon nanotube suspension in gravity-assisted thermosyphon

Thermo-physical properties of water-based single-walled carbon nanotube nanofluid as advanced coolant

Characteristics of Carbon Nanotube Nanofluid and Heat Transfer in Gravity Heat Pipe

Supercooling Behaviour and Non-Isothermal Crystallization Processes of Aqueous Suspensions of Carbon Nanotubes

Experimental study on the thermal conductivity enhancement of water based nanofluids using different types of carbon nanotubes

An Experimental Study of Boiling Heat Transfer During Quenching of Nanofluids with Carbon Nanotubes of Various Sizes

Quenching boiling of aqueous suspensions with carbon nanotubes

Experimental Study On Thermophysical Properties Of Nanotubes And Nanofluids

Pool Boiling Heat Transfer During Quenching in Carbon Nanotube (Cnt)-Based Aqueous Nanofluids: Effects of Length and Diameter of the CNTs

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Modeling of thermocapillary flow to purify single-walled carbon nanotubes

The Effect of Carbon Nanotubes on the Viscosity and Surface Tension of Heat Transfer Fluids—A Review Paper

Temperature Dependent Thermal Conductivity Increase of Aqueous Nanofluid with Single Walled Carbon Nanotube Inclusion

Regulatable Thermal Conductivity and Excellent Mass Transport of Water-Filled Carbon Nanotube As Capillary Wicks

Nanoengineering Heat Transfer Performance At Carbon Nanotube Interfaces

Heat Transfer and Pressure Drop of Nanofluids Containing Carbon Nanotubes in Laminar Flows

Interface Effect on Thermal Conductivity of Carbon Nanotube Composites

Heat Transfer and Flow Behaviour of Aqueous Suspensions of Titanate Nanotubes (Nanofluids)

Molecular study on convective heat transfer of nanofluid in nanochannel: effect of CNT particles

Thermal transport across the interface between a suspended single-walled carbon Nanotube and air