Abstract:Modification on PEMs to improve their thermal and chemical stability and to depress their methanol crossover is another approach to provide high performance PEMs. Organic-inorganic nanocomposites represent a useful approach to PEM modification. Layered clays and silica nanoparticles are two major inorganic reinforcements in PEM modifications. Clay incorporation into PEMs introduces a winding pathway for a methanol molecule to reduce their methanol crossover. The presence of silica nanoparticles in PEMs keep their hydrophilicity to maintaining water and improve their thermal and mechanical stability. The methanol crossover of PEMs is also depressed with formation of polyelectrolyte-silica nanocomposites as reduction of their swelling degree in methanol fuel solutions. Incorporation of nanosized inorganic reinforcements to proton exchange membranes, although brough about membrane stabilization, however would certainly lower their ion exchange capacity and proton conductivity. To overcome this problem, Lee et al prepared sulfonated montmorillonite to modify Nafion. The prepared composite membranes showed dramatic decreases in methanol permeability and comparable proton conductivity to pristine Nafion membranes. Bébin et al also used sulfonated Laponite particles to prepare Nafion/clay-SO3H composite membranes. The performance of the membrane-electrolyte assembly using the composite membrane is better than the one of a Nafion membrane. The above articles suggested that uses of sulfonated inorganic particles in preparation of polyelectrolytes nanocomposite membranes is an effective approach to improve the proton exchange membrane performances. Instead of clay, in this work silica nanoparticles and their sulfonated forms (silica-SO3H) were utilized in preparation of polyelectrolyte/silica nanocomposite membranes. Sulfonated poly(phthalazinone ether ketone) (sPPEK) with a high content of sulfonic acid groups is utilized as the proton conducting material. The properties of the prepared nanocomposite PEMs are examined and discussed. The chemical structures of sPPEK polyelectrolyte and silica-SO3H nanoparticles are shown in Figure 1. Mixing of these two substances in DMAc formed homogeneous and transparent solutions. sPPEK/silica-SO3H nanocomposite membranes possessing various silica-SO3H contents (NM-SA-X, X = silica-SO3H (g)/100g of sPPEK in solutions) were prepared from solution casting on glass plates. All obtained membranes showed high transparency, indicating the silica particles did not aggregate during membrane preparation.

Mineral nanofibre reinforced composite polymer electrolyte membranes with enhanced water retention capability in PEM fuel cells

Improved Performance of Sulfonated Poly Ether Ether Ketone/three-Dimensional Hierarchical Molybdenum Disulfide Nanoflower Composite Proton Exchange Membrane for Fuel Cells

Composite Proton Conductive Membranes for Elevated Temperature and Reduced Relative Humidity PEMFC

Achieving Better Balance on the Mechanical Stability and Conduction Performance of Sulfonated Poly(ether Ether Ketone) Proton Exchange Membranes Through Polydopamine/polyethyleneimine Co-Modified Poly(vinylidene Fluoride) Nanofiber As Support

Property Enhancement Effects of Side-Chain-Type Naphthalene-Based Sulfonated Poly(arylene ether ketone) on Nafion Composite Membranes for Direct Methanol Fuel Cells

2136 Congenital microcoria: Association with myopia and glaucoma

Enhanced properties of Nafion nanofibrous proton exchange membranes by altering the electrospinning solvents

Anisotropic membrane with high proton conductivity sustaining upon dehydration

Engineering Mesoporosity Promoting High-Performance Polymer Electrolyte Fuel Cells

Novel Nafion composite membranes with mesoporous silica nanospheres as inorganic fillers

Enhancing Proton Conductivity and Dimensional Stability of Nanofiber Proton Exchange Membranes through In Situ Growth of MOF-Modified PVDF Nanofibers

Composite membranes of Nafion and poly(styrene sulfonic acid)-grafted poly(vinylidene fluoride) electrospun nanofiber mats for fuel cells

Novel Composite Proton Exchange Membrane with Connected Long-Range Ionic Nanochannels Constructed Via Exfoliated Nafion-Boron Nitride Nanocomposite.

Porous Nafion nanofiber composite membrane with vertical pathways for efficient through-plane proton conduction

Silica nano-particle/polyelectrolyte nanocomopsite membranes for direct methanol fuel cells

Novel-SiO2-Doped Proton Exchange Membrane for Self-Humidifying Fuel Cell

Electrochemical Analysis of Polymer Membrane with Inorganic Nanoparticles for High-Temperature PEM Fuel Cells

Fabricating rapid proton conduction pathways with sepiolite nanorod-based ionogel/Nafion composites via electrospinning

Novel Nanocomposite PEM Membranes with Continuous Proton Transportation Channel and Reinforcing Network Formed by Electrospinning Solution Casting Method

Improved performance of nafion membranes by blending ultra-high molecular weight polyvinylidene fluoride

Construction of three-dimensional proton-conduction networks with functionalized PU@PAN/UiO-66 nanofibers for proton exchange membranes