Abstract:The floating support friction plate plays a crucial role in the functioning of high-power hydraulic disk brakes (HDBs). When the brakes are not engaged, there is inevitably an impact between the floating friction plate and the inner hub of the HDB due to the clearance between the teeth of the spline coupling. This impact force can become excessive as the clearance expands, thereby increasing the risk of failure of the friction plate and hub teeth. However, there is a lack of an effective dynamic model that considers non-uniform clearances for the spline coupling in an HDB with floating friction plate. To address this issue, a new dynamic modeling method is proposed for HDBs with floating friction plate, which takes into account the nonlinear impact resulting from non-uniform and time-varying teeth clearances. A nonlinear dynamic model for the entire transmission system is first established, considering the presence of the floating friction plate. Subsequently, a calculation method for the impact force on floating friction plate is presented, which includes the coupling effects of tooth clearance expansion and indexing errors. Moreover, influences of clearance expansion and operating conditions on the nonlinear characteristics of the impact force and dynamic response are investigated. Finally, an experimental setup is developed to measure the impact force on the floating friction plate, thereby verifying the proposed method. The results demonstrate that the predicted impact force, based on the proposed method, closely agrees with the test data in terms of both the time domain waveform and spectrum. Consequently, it can be concluded that this paper presents an effective modeling method for HDBs with floating friction plates, enabling a thorough study of the influence of nonlinear tooth clearance impacts.

Modeling and Dynamic Simulation for Head/disk and Suspension Interface During Load/Unload Process of a Hard Disk Drive

Modeling and simulation of wear for alignment mechanism of large aircraft component

Loading Design for Comprehensive Performance Test Bench of Drive Axle Assembly

Microtribology of Hard Disk Drive for High Density Recording

MODAL TESTING AND FINITE ELEMENT MODELLING OF SUBSYSTEM IN HARD DISK DRIVE

Lubricating Simulation Analysis of Connecting Rod Bearing Based on AVL-EXCITE

Loading Methodology and Dynamics Analysis of the Digital-Servo Hydraulic Cylinders Group in Large Wind Turbine Drivetrain Test Bench

Experimental Study of the Slider-Lube/Disk Contact State and Its Effect on Head-Disk Interface Stability

Research on the Design and Fabrication of Air Bearing Sliders in Hard Disk Drives

Nano-and Micro-Actuations of Hard Disk’s Head Positioning System: Actuator Design and Evaluation of Performance

Dynamic Characteristics Analysis of the Hub Direct Drive-Air Suspension System from Vertical and Longitudinal Directions

Modeling and compensation of low fly-height vibrations in high density Hard Disk Drive servo systems

Dynamic Characteristics of Hard Disk Drive Spindles Supported by Hydrodynamic Bearings

Visco-elastohydrodynamic Lubrication and Wear Model Amended by Deformation Velocity

Dynamics of Drive Axle System with Effects of Input Torque

Dynamic modeling for hydraulic disk brake with floating supported friction plate considering nonlinear tooth clearance impact

Dynamic Modeling and Analysis for High-Speed Bag-Pushing Mechanism

Rigid-Elastic Coupling Modelling Of Air Suspension And Fatigue Life Prediction Of Its Key Part For Heavy-Duty Truck

Experimental Study of Head-Disk Interface Flyability and Durability at Sub-1-nm Clearance

Contact Lubrication Performance of Axle Bearing Assembly of Railway Passenger Cars under the High Speed Condition

A Molecular Dynamics Study on Lubricant Perfluoropolyether in Hard Disk Driver