Abstract:Background The Shanghai synchrotron radiation facility (SSRF) is a third generation light source. It has been in operation for user experiment in decay mode since 2009. Meanwhile, the top-up operation is also under exploration in order to provide users with stable beam. A key technique for top-up mode is optimizing the injection efficiency by precisely controlling the injecting bunch charge. Therefore, it is essential to measure precisely the bunch charge at the high-energy transport line. The direct-current current transformers (DCCT) can measure the average beam current but can't measure the single bunch charge. Although the integrating current transformer (ICT) can measure the individual bunch charge, it is sensitive to different background noise with a resolution of less than 1% and even worse under low bunch charge case. [Purpose] This study aims to improve the measuring resolution for the injected individual bunch charge by using cavity charge monitor. [Methods] Since the cavity monitor has high sensitivity and high resolution, it will be used to extract the bunch charge information. Normally, the cavity monitor works at C-band frequency and the generated radio frequency signal (RF) has to be down-converted to intermediate frequency (IF) signal. Thus a dual-cavity monitor working at different frequencies was developed to realize the two RF signals self-mixing. Moreover, because of the limited signal sampling rate, the four channel signal splicing scheme with strict synchronous phase-locked sampling technique was addopted to further improve the sampling rate. [Results] The experimental results show that IF signal amplitude is linear to the bunch charge quantity. Moreover, the test results presents the measuring sensitivity is better than 0.03%. [Conclusion] The novel dual cavity bunch charge system works well and meets the requirement of injection bunch charge measurement.

An Integrating Current Transformer for Fast Extraction from the HIRFL-CSR Main Ring

The New Beam Current Transformer for IR-FEL Facility at NSRL *

Applications for Synchrotron Radiation in Inertial Confinement Fusion Research

Detectors for slowly extracted ions in HIRFL-CSR

DCCT System Design for SSRF Storage Ring

Self-integrating Current Sensor for Fast Pulsed Current Monitor in Transmission Line.

A Residual Gas Ionization Profile Monitor Developed for HIRFL-CSR

Overview On The Hirfl-Csr Facility

A T0/Trigger detector for the External Target Experiment at CSR

Single-Shot Spatial-Temporal Electric Field Measurement Of Intense Terahertz Pulses From Coherent Transition Radiation

Design and performance testing of a T0 detector for the CSR External-target Experiment

Simulation Studies of the Beam Monitor for the CSR External-Target Experiment

Beam test results of the prototype of the multi wire drift chamber for the CSR external-target experiment

Beam test study of the MRPC-based T0 detector for the CEE

Research on the Methods of Measuring High Frequency Small Current in Large Power Frequency Current by Current Transformer

Longitudinal and Transverse Measurement to Evaluate the Beam Impedance on a Ceramic Ring-Loaded Thin-Wall Vacuum Chamber in BRing at HIAF

Prototype Front End Electronics of TO Detector in the External Experiment of CSR in HIRFL

Tune Measurement System for HIRFL-CSR

Measurement of Current of Standing Waves along the Transmission Line on EAST Ion Cyclotron Resonant Heating System

Performance of the continuous ions suppression TPC prorotype for circular collider

Study on precise bunch current measurement based on dual cavity monitor