Abstract:Objective: This research focused on FMVSS301, which is required for higher energy absorption as a regulation for rear-end collisions. Since they are offset collisions, the deformation of the non-collision side frame, which does not directly contact the barrier, is less than on the collision side. The reason is that the rear bumper beam with curvature is deformed into a straight shape by the load from the barrier, resulting in an asymmetrical load distribution from the barrier that is biased toward the collision side. Therefore, the objective of this research was to construct a new bumper beam structure that reduces the difference in the load input to both frames and increases the energy absorption of the non-collision side frame. Method: The basic principle is to generate a counterforce against the lateral loads during transmitting the load from barrier to the frames. To achieve this, a bow-shaped rear bumper beam structure was devised. The rear bumper beam corresponds to the bow and the newly added connection plate to the string. The lateral load increase is suppressed and load distribution to the rear frame is maintained. Results: The designed rear bumper beam and rear components equipped with the rear bumper beam were both prepared and evaluated by drop test. With testing of the rear bumper beam, it was demonstrated that the load in the lateral direction, which conventionally generates over 80 kN, could be canceled. Tests of the rear component demonstrated that load distribution to the rear frame could be maintained, and the energy absorption of the non-collision side frame could be enhanced by 35 times. The total energy absorption of the barrier and the two frames was demonstrated to increase 2.9 times. Conclusion: The bow-shaped rear bumper beam was designed to distribute the load evenly to the collision and non-collision side frames, and to deform both frames, thereby achieving a higher energy absorption of the entire vehicle body. This is expected to be applicable to electric vehicles and FCVs, which require more energy absorption with increased vehicle weight.

Structural improvement of the longitudinal beams of a production SUV based on frontal impact protection

Optimization Design of Longitudinal Beam Structure in Car Frontal Crash

Simulation of Automobile Offset Frontal Impact and Structure Improvement

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Body Structure Optimization of a Car in the Frontal Crash

Frontal crashworthiness structure analysis and optimization of electric vehicle

Optimization Design of Body Structure in Offset Crash

Design and optimisation of vehicle frontal bumper beam with alternative carbon fibre-reinforced plastics in corrugated sandwich structure

Structure Optimizative of Rear Seat Support Beam in Trunk Impact

Crashworthiness design of vehicle structure with tailor rolled blank

Axial crashworthiness and multi-objective optimization of single-hat beams with sinusoidal cross-sections

Effect of high-density structural foam on crashworthiness of vehicle front side-rail and its application

New load transfer structure to reduce body deformation in side collisions

Load distribution structure of rear bumper beam to enhance vehicle body energy absorption in rear-end collisions

An thin-walled beam enforcement structure and its dynamic bending performance analysis

Optimization Design of Energy-absorbing Panel of Front Beam for a Specific Vehicle

Improvement of vehicle crashworthiness for full frontal impact based on energy flow analysis

Design of Straight-Retractable Energy-Absorbing Beam for Electric Cars and Its Crashworthiness Analysis

Optimization of the Frontal Rail Based on Composite Material

Simulation Analysis of Inner Force Characteristics of Car Body Thin-walled Beam Structures Subject to Lateral Impact

Design of a Conceptual Bumper Energy Absorber Coupling Pedestrian Safety and Low-Speed Impact Requirements