Abstract:Objective: This research focused on FMVSS301, which is required for higher energy absorption as a regulation for rear-end collisions. Since they are offset collisions, the deformation of the non-collision side frame, which does not directly contact the barrier, is less than on the collision side. The reason is that the rear bumper beam with curvature is deformed into a straight shape by the load from the barrier, resulting in an asymmetrical load distribution from the barrier that is biased toward the collision side. Therefore, the objective of this research was to construct a new bumper beam structure that reduces the difference in the load input to both frames and increases the energy absorption of the non-collision side frame. Method: The basic principle is to generate a counterforce against the lateral loads during transmitting the load from barrier to the frames. To achieve this, a bow-shaped rear bumper beam structure was devised. The rear bumper beam corresponds to the bow and the newly added connection plate to the string. The lateral load increase is suppressed and load distribution to the rear frame is maintained. Results: The designed rear bumper beam and rear components equipped with the rear bumper beam were both prepared and evaluated by drop test. With testing of the rear bumper beam, it was demonstrated that the load in the lateral direction, which conventionally generates over 80 kN, could be canceled. Tests of the rear component demonstrated that load distribution to the rear frame could be maintained, and the energy absorption of the non-collision side frame could be enhanced by 35 times. The total energy absorption of the barrier and the two frames was demonstrated to increase 2.9 times. Conclusion: The bow-shaped rear bumper beam was designed to distribute the load evenly to the collision and non-collision side frames, and to deform both frames, thereby achieving a higher energy absorption of the entire vehicle body. This is expected to be applicable to electric vehicles and FCVs, which require more energy absorption with increased vehicle weight.

Structure Optimizative of Rear Seat Support Beam in Trunk Impact

Simulation of Automobile Offset Frontal Impact and Structure Improvement

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Optimization Design of Body Structure in Offset Crash

Optimization Design of Longitudinal Beam Structure in Car Frontal Crash

Body Structure Optimization of a Car in the Frontal Crash

Frontal crashworthiness structure analysis and optimization of electric vehicle

Topological optimisation design of passenger car seat backrest frame based on multiple-loading conditions

Effect of rear-seat submarine on dummy injury and it’s optimization

Crashworthiness design of vehicle structure with tailor rolled blank

Analysis and Improvement for the Failure of Seat Belt Anchor of a Car Based on Simulation and Experiment

Optimization Design of Anchorage Structure for Safety Belt on Rear Floor

Design of Straight-Retractable Energy-Absorbing Beam for Electric Cars and Its Crashworthiness Analysis

The Improvement of Front Cross Member in Vehicle Offset Impact

An thin-walled beam enforcement structure and its dynamic bending performance analysis

Combined with finite element analysis of car seat safety performance improvement

Structure design of LFT passenger car seat structure based on topology optimisation

Design and optimisation of vehicle frontal bumper beam with alternative carbon fibre-reinforced plastics in corrugated sandwich structure

Optimisation design of CFRP passenger car seat backplane based on impact characteristics

Load distribution structure of rear bumper beam to enhance vehicle body energy absorption in rear-end collisions

Car Seat Backrest Static Strength Experiment and Simulation