Abstract:Currently, a gap in understanding the mechanism of interlayer explosives exists. This study systematically investigated this mechanism using TP 270C/SUS 821L1 to fill this knowledge gap. By comparing the outcomes of direct and interlayer welding through methods such as optical microscope (OM), computed tomography (CT), electron probe micro-analysis (EPMA), electron backscatter diffraction (EBSD), transmission electron microscopy (TEM), nanoindentation, and tensile shear test, it was found that an interlayer can significantly lessen the energy at the target interface. This was further evident when comparing welds with varying interlayer thicknesses, showing that thinner interlayers lead to less energy transfer between the flying plate and the interlayers. Notably, at an interlayer thickness of 0.1 mm, the welding interface appeared irregular. The smoothed particle hydrodynamics (SPH) method was employed to simulate the welding, highlighting the interlayer's impact on factors like pressure, jet, temperature, and melting. This simulation also explained why the 0.1 mm interlayer had an irregular interface due to jetting affecting the welding between the flyer plate and interlayer. The study also analyzed the weldability window in interlayer explosive welding, noting how the interlayer influenced its upper and lower limits. The relation between interlayer thickness and the constant k in the lower limit was examined, along with the minimum velocity needed for the flyer plate to generate a jet V P . Their relationship satisfied exponential functions in the detonation velocity range of 1800–3000 m/s. This study thus established a link between traditional and interlayer explosive welding.

Simulation for the Influences of Explosive Amount on Explosive Welding of Two-Layer Tubes

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Numerical Simulation of Internal Explosion and Dynamic Response Analysis for Vertical Cylindrical Steel Tanks

Numerical Study on Mechanism of Explosive Welding

Numerical study on atmospheric explosive welding based on the 2D structured arbitrary Lagrangian-Eulerian method

Interface Microstructure and Numerical Simulation Investigations of Ni/TC18 Composite Tube Fabricated by Explosive Welding

A two steps Lagrangian–Eulerian numerical model for the simulation of explosive welding of three dissimilar materials joints

Numerical Studies on Explosive Welding with ANFO by Using a Density Adaptive SPH Method

Experimental and numerical study on the mechanism of interlayer explosive welding

Investigation of Explosive Welding Through Whole Process Modeling Using a Density Adaptive SPH Method

Microstructure Simulation and Experiment for the Weak Weld Joint of a Domed Storage Tank during an Explosion Based on the Cellular Automaton Method

Numerical Simulation of Tube-Plate Welding Structure with T-Shaped Sections

A novel dynamic self-constrained explosive welding method for manufacturing copper-steel bimetallic tube

3D numerical simulation of linear friction welding of 45# carbon steel

Numerical simulation and analysis of welding of drive axle housing and axle tube

Explosive welding of Al alloys and high strength duplex stainless steel by controlling energetic conditions

Mechanism of Explosive Technique on Relieving Welding Residual Stresses

Numerical Analysis of Gas Explosion Process in Linked Vessels

Numerical Simulation of Tube Manufacturing Consisting of Roll Forming and High-Frequency Induction Welding

Some Applications of Interlayer Explosive Welding

A Study on Explosion Welding Defects of Large-Sized Plates