Abstract:Ice slurry has been widely used in the field of building air conditioning because of its high energy storage density. The helically coiled tube heat exchangers (HCTHXs) utilizing ice slurry as the cooling medium presents a potential value in decreasing energy consumption for building air conditioning due to their high thermal efficiency. However, the design for HCTs utilizing ice slurry as the cooling medium is undeniably a challenging task due to its complicated structure and operation conditions. In this study, the response surface methodology (RSM) is utilized to construct the mathematical models, and the non-dominated sorting genetic algorithm (NSGA-II) is applied to optimize the thermo-fluidic behaviors of ice slurry in HCTs. Initially, five design parameters are determined, consisting of three operating parameters (inlet velocity (u in), inlet ice volume fraction (α in), ice particle diameter to tube diameter ratio (d s/D)) and two geometrical parameters (coil pitch to tube diameter ratio (H/D) and coil radius to tube radius ratios (R c/r)). Next, numerical investigations are structured using the Box-Behnken design (BBD). Analysis of variance (ANOVA) is utilized to assess the validity and dependability of the generated regression models. To illustrate the interactions between each set of design parameters, response surface analysis is performed. In the end, the Pareto optimal frontier is determined using NSGA-II, in conjunction with the regression models generated through RSM. The obtained Pareto optimal solution resulted in a Nu of 223.5768 and a f of 0.029, representing improvements of 106.8 % and reductions of 28.86 % compared to the original design, respectively. The corresponding design variables is u in = 3.9974, α in = 29.3086 %, d s/D = 0.40408, H/D = 3.5908 and R c/r = 22.6885. This study establishes a robust and effective groundwork for the advancement and utilization of HCTHXs utilizing ice slurry as the cooling medium.

Research on the ice slurry generator using the direct contact heat transfer of gas and water solution

Analysis of Ice Slurry Production by Direct Contact Heat Transfer of Air and Water Solution

Experimental study of double direct contact ice slurry generator

Heat Transfer Performance of a Single Air Bubble in Direct Contact Ice Slurry Generator

Parameter analysis and design point of direct-contact ice slurry generator

Study on ice slurry production by air direct contact method on basis of utilizing LNG cold energy

Study on heat transfer characteristics of dynamic ice slurry

Numerical investigation on heat and mass transfer characteristics of ice slurry in pulsating flow

Research Developments and Applications of Ice Slurry

Review of Ice Slurry Pigging Techniques for the Water Supply Industry: Engineering Design and Application

Investigation of circumferential distribution of slag deposited on slag screen of Shell coal gasifier

Experimental Study On Heat Transfer Characteristics Of Conductive Plastic Ice-On-Coil

Performance improvement of vertical ice slurry generator by using bubbling device

Development of a novel continuous nanofluid ice slurry generator: Experimental and theoretical studies

Study on flow and heat transfer characteristics of salt solution ice slurry

Numerical investigation of hydraulic and heat transfer characteristics of two-phase ice slurry in helically coiled tubes

Study of the convective heat transfer during full melt off of ice slurry in laminar and non-Newtonian flows

Research and amelioration of ice slurry making equipment

Review on high ice packing factor (IPF) ice slurry: Fabrication, characterization, flow characteristics and applications

Study on concentration distribution and viscosity of ice slurry flow

Multi-objective optimization of two-phase ice slurry flow and heat transfer characteristics in helically coiled tubes with RSM and NSGA-II