Abstract:Packaging materials have a great impact on the performance and reliability of light-emitting diodes (LEDs). In this study, we have prepared high performance LED devices through encapsulating LEDs by epoxy materials incorporated with filler powders. A set of evaluation methods have also been established to characterize the reliability of LED devices. No delamination or internal cracking between packaging materials and lead frames has been found for the encapsulated high performance LED devices after the package saturation with moisture and subsequent exposure to high-temperature solder reflow and thermal cycling. Four kinds of inorganic silica fillers, namely, quartz, fused silica, cristobalite, and spherical silica, and one kind of organic filler, that is, spherical silicone powder, were incorporated into the epoxy packaging materials to compare their effects on performance of LED devices. The properties of epoxy packaging materials and LED devices were studied by differential scanning calorimetry (DSC), thermogravimetric analyses (TGA), dynamic mechanical analysis (DMA), thermomechanical analyzer (TMA), ultravioletvisible spectrophotometer (UV-vis), scanning acoustic microscopy (SAM), and scanning electron microscopy (SEM). Except the spherical silicone powder filled epoxy materials, all the other filled systems showed lower equilibrium water sorption content and smaller water diffusion coefficient in both water sorption and moisture sorption tests. The coefficient of thermal expansion (CTE) values were also decreased with the addition of fillers, and the systems filled with quartz, fused, and filled with spherical silica gave the best performance, which exhibited the reduced CTE values both below and above Tg. The results of TGA essentially showed no difference between filled and unfilled systems. The glass transition temperature changed little for all the filled systems, except the one incorporated with spherical silicone. The modulus at room temperature increased with the addition of fillers. The light transmittance of filled epoxy materials varied with fillers after UV and thermal aging.

Effect of die-attach material on performance and reliability of high-power light-emitting diode modules

Improved Thermal Performance of High-Power Led by Using Low-Temperature Sintered Chip Attachment

Improvement of high-power LED performance with sintered chip attachment

Effects of Bonding Materials on Optical–Thermal Performances and High-Temperature Reliability of High-Power LED

Study On Solder Bonding Technology And Its Failure Mechanism

Study on die-bonding key technology of UV LED packaging

Potential interconnect technologies for high power LEDs assemblies

Thermal Simulations of a UV LED Module with Nanosilver Sintered Die Attach Process on Graphene-Coated Copper Substrates

Enhanced Heat Dissipation of High-Power Light-Emitting Diodes by Cu Nanoparticle Paste

Comparative Study of Die-Attach Materials for LED Die Bonding

A GaN HEMT Integrated Power Module with Silver Sintering Processes

Thermal improvement of die attach by using PDMS-grafted particles as filler and Its application in solid state lighting

Temperatures and Thermal Stresses in High-Power Light Emitting Diodes

Investigation of Thermal Characteristics of A Silicon-Based Led Packaging Module

Failure Analysis Of Die-Bonding Interfaces Between Led Chip And Heat Sink

Emerging Lead-Free, High-Temperature Die-Attach Technology Enabled By Low-Temperature Sintering Of Nanoscale Silver Pastes

Interface Contact Thermal Resistance of Die Attach in High-Power Laser Diode Packages

Effects of Voids on Mechanical and Thermal Properties of the Die Attach Solder Layer Used in High-Power LED Chip-Scale Packages

A Silicon-Aluminum Micro Heat Sink for Light Emitting Diode (led) Chips

Revolutionizing Power Module Manufacturing: Large Area Sintering with Silver Pastes for Enhanced Performance and Cost-Effectiveness

High-performance Light-Emitting Diodes Encapsulated with Silica-Filled Epoxy Materials.