Abstract:The objective of this paper is to discuss the influence of geometric parameters on the performance of the rotational hydrodynamic cavitation reactor (RHCR) using numerical method. The novel RHCR is implemented by modifying a centrifugal impeller into a new one using the annular slit constriction (ASC) with circumferentially distributed blind holes. The cavitation intensity and cavitation generation rate are selected to evaluate the cavitation performance, the head is used to assess conveying performance, and the entropy generation theory is used to evaluate the energy loss in the impeller. The effect of the axial width, radial length and radial position of the ASC on the cavitating flow of the RHCR is investigated by CFD method. The results indicate that three patterns of cavitation are induced in the RHCR, including separation cavitation, vortex cavitation and shear cavitation. The axial width, radial length and radial position of the ASC are the important geometric parameter that affect the performance of the RHCR. A small width is superior to a large width in terms of cavitation performance, although the conveying performance suffers as a result. The energy loss in the impeller initially increases and then decreases as the width decreases. Both a reduction in radial length and radial position leads to higher cavitation and conveying capacity, accompanying slight increase in energy loss. Compared to the original model, the RHCR with an axial width of 3 mm, a radial length of 17 mm, and a radial position of 0.541 achieves the highest performance.

Research on Effects of Size Deviation on Waterjet Hydrodynamic Performance by Means of CFD

Design Method of Water Jet Pump Towards High Cavitation Performances

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Modeling of the Cutting Front Profile in Abrasive Water Jet Machining Based on the Energy Balance Approach

Numerical study of the hydrodynamic performances of surface piercing propeller

Waterjet Penetration Simulation by Hybrid Code of SPH and FEA

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

Numerical simulation and design optimization of a circulating water channel on hydrodynamic flow performance

Hydrodynamic Design of an Advanced Submerged Propulsion

Numerical investigation of cavitation-vortex interaction in a mixed-flow waterjet pump

Cavitating Flow Analysis and Design Optimization for a Waterjet Mixed Flow Pump

Experimental and numerical study on cavitation pulsating pressure of water-jet propulsion axial-flow pump

Influence of Inlet Duct Length on the Hydraulic Performance of the Waterjet Propulsion Device

Design Optimization Of A Mixed Flow Waterjet Pump For Performance Improvement Involving Cavitation

Numerical Study on the Stall Behavior of a Water Jet Mixed-Flow Pump

Numerical investigation of effect of geometric parameters on performance of rotational hydrodynamic cavitation reactor

Research on Cavitation Wake Vortex Structures Near the Impeller Tip of a Water-Jet Pump