Abstract:The application of RF cavity beam position monitors (CBPM) is essential for precise beam position measurements in X-ray Free-Electron Lasers (XFEL) and linear colliders. This paper addresses the solution to the inter-bunch signal interference when the bunch separation is as short as nanoseconds. The signals can overlap from bunch to bunch, which can induce appreciable error in evaluating beam position. We propose a conceptual method to eliminate the dominant signal overlap under a quadrature phase offset condition. Using this method, the elimination automatically occurs in the process of signal digitalization. The dominant interference that is contributed by the last bunch can be reduced over an order of magnitude in a conventional CBPM system. In addition, the required bandwidth can be effectively reduced by a factor of 2, and the design challenge for a wideband CBPM is relaxed. The method was demonstrated in an analytic approach by simulating the signal evolution in the RF front end of electronics built in MATLAB code. In the practical concern of applying this method, the factors that perturb the elimination have been examined as well. Based on the numerical result, the CBPM prototype has been designed for the pre-research plan of future high repetition rate hard XFEL at Chinese Academy of Engineering Physics. The combined simulations in CST and MATLAB on the CBPM prototype indicate agreement with the result obtained in the analytic approach.

Photon beam position measurement system based on four-quadrant detector

An Axial Displacement Measurement Relying on the Double-Helix Light Beam

A quadrant detector based laser alignment method with higher sensitivity

A Novel Method to Simultaneously Measure the Straightness

Analyzing characteristic of the four-quadrant detector applied to laser alignment

A Systemic Model for Simultaneously Measuring Three dimensional Rotation Angles of the Linear Guide Track [J]

New Diagnostic Systems on HL-2A

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

Application and Design of Photon Beam Position Monitor in HLS

A method of bunch by bunch measurement at nanoseconds interval by using cavity beam position monitors

Design and Measurement of Signal Processing System for Cavity Beam Position Monitor

In situ beam trajectory tilt measurement based on single cavity beam position monitor

Development Of A Split Photon Beam Position Monitor For Hls

Subpicosecond Beam Length Measurement Study Based on the Tm010 Mode

Airborne Laser Communication System with Automated Tracking

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

High Precision Position Measurement Method for Laguerre-Gaussian Beams Using a Quadrant Detector

A Pulsed Ultraviolet Laser Positioning System Based on 4H-SiC Four-Quadrant Photodetectors

Hefei light source storage ring bunch by bunch 3D position measuring system is introduced and a preliminary study is shown

High-precision laser beam lateral displacement measurement based on differential wavefront sensing

Methods of Measurement for the Beam-Based Alignment System in HLS