Abstract:The clock source is the most fundamental part of the microwave-based sensing system. Its phase noise and jitter performance directly determine the detecting accuracy of the entire system. Therefore, there are many applications that require a high-performance low-jitter clock source integrated on a single board together with other functional circuits. However, with the increased integration level of single-board circuits, the frequency of the onboard signal, and the requirements for miniaturization, the influence of power supply noise on the clock source generation module cannot be ignored. In other words, the power supply induced jitter (PSIJ) will arise inevitably to some extent. In addition, reducing the PSIJ has become increasingly difficult by optimizing the power supply network. This paper analyzes the output clock jitter of the phase-locked loop (PLL) based clock source under the influence of power supply noise and proposes a reasonable optimization design of the loop filter bandwidth to further suppress the impact of the power supply noise (PSN). The simulation results show that using the optimized loop filter, the output clock jitter can be attenuated by 78% in the case that the output has been influenced by the wideband noise and the bump power supply noise.

A Design Optimization Method for Low Jitter Clock PLLs

Design of Charge Pump for High-Speed Phase-Locked Loop

Design of monolithic Phase-Locked Loop circuit for high-speed serial data link

Design of a Low Jitter Phase Locked Loop

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

Optimized System Design for Fully Integrated Fractional-N Pll

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Self-Biased PLL with Low Power and Compact Area

A 4.7ghz Synchronized-Multi-Reference PLL with In-Band Phase Noise Lower Than Reference Phase $\text{noise +20}\Text{logn}_{\mathrm{d}\mathrm{i}\mathrm{v}}$

A Low Jitter PLL in a 90nm CMOS Digital Process

A Method to Reduce Jitter Due to Power Noise by Optimizing Loop Filter in PLL Based Clock Source

Design Of Low-Jitter 1-Ghz Phase-Locked Loops For Digital Clock Generation

Low Jitter and Low Power PLL : Towards the Utopia

A 2-GHz CMOS phase-locked loop clock generator research and design

An Adaptive-Bandwidth CMOS PLL with Low Jitter and a Wide Tuning Range

Design of Low-noise、Low-power Consumption CMOS CPPLL

Frequency Stability Optimization of an OEO Using Phase-Locked-loop and Self-Injection-locking

A 4224 MHz Low Jitter Phase-Locked Loop in 0.13-Μm CMOS Technology

Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur

A Low Spur, Low Jitter 10-Ghz Phase-Locked Loop in 0.13-Μm CMOS Technology