Abstract:The possibility of using lasers to achieve previously unobtainable states of matter in the laboratory gained much attention following the demonstration of the first pulsed laser in 1960. In the following few years there was plenty research activity as attempts were made to increase the peak power and focused intensity in order to reach extreme conditions within the laboratory. Laser-acceleration technology is rapidly developing. Petawatt class lasers have been constructed for specific research activities, including particle acceleration, inertial confinement fusion and radiation therapy, and for secondary source generation (X rays, electrons, protons, neutrons and ions). As a new source of ionizing radiation, dose measurement in ultra-intense and ultra-short laser facilities is of great value for radiation protection of the environment, occupational staff and shielding design in laser device design stage. Owing to the pulsed and mixed characteristics of radiation field around the laser facility, it is really challenging to accurately measure the dose equivalent induced by bremsstrahlung photon in the target chamber of the laser facility. Moreover, the rationality of dose assessment model needs more experimental data and to be further verified. To reach this point, the Monte-Carlo program FLUKA was employed to characterize the radiation filed distribution. Firstly, a complete and thorough target chamber module was established according to the XG-Ⅲ geometry parameter and material composition. The in-chamber and out-chamber dose distribution were then calculated and analyzed based on the existing theoretical model of electron source term and typical experimental conditions. The electron energy distribution, characteristic electron temperature, scaling laws and laser-to-energy conversion efficiency were introduced. Secondly, the typical electron spectrum was divided into four intervals. The portion of different energy intervals to the total equivalent dose was determined. Thirdly, a bremsstrahlung photon dose equivalent measuring module was designed and optimized for ultra-intense and ultra-short laser facilities. The simulation results indicate that: 1) The electron dose equivalent is higher than the bremsstrahlung photons both inside and outside the target chamber; 2) The dose equivalent contribution of 0.15 MeV electron energy interval to the total energy range is dominant, and the module was design based on the conclusion; 3) The designed module mainly consists of PMMA and metallic shielding material. With this approach, the module can reduce the electron dose equivalent to 0.3% and photon dose equivalent to 69.1%. The dose ratio of electron to photon is about 128%. In addition, 5% of the total photon dose is contributed by the occurrence of bremsstrahlung of highenergy electron in PMMA.

Correction Factor of Electron Loss for Medium-energy X-Ray Free-air Ionization Chamber Calculated with the Monte Carlo Method

Determination of Correction Factors for Small Field Based on Measurement and Numerical Calculation using Cylindrical Ionization Chambers

Monte Carlo Simulation of the Exposure Factor

Monte Carlo Method for Calculating Particle Radiation Detector Correction Factors

Measurement of the Wall Correction Factor of a Spherical-cylindrical Cavity Ionization Chamber

Monte CarIo SimuIation of PhysicaI Parameters for Air Kerma Measurement by Graphite Pancake Ionization Chamber

Monte-Carlo Calculation and Measurement of Wall Correction Factor for Spherical Graphite Ionization Chamber

Monte Carlo simulation of initial and volume ion recombination correction factor in plane parallel ionization chambers exposed to ion beams

Study on energy-loss compensation correction method for fission fragments

Characterization of the new free-air primary standard for medium-energy X-rays at CMI

Air kerma reference field with high energy photons using a 15 MeV electron beam from a clinical linear accelerator

Study on Correction Method of Counting Loss below the Threshold for Low Energy Radionuclides Based on Monte Carlo Simulation

A Calculation of Backscattering Factor Database for Quantitative Analysis by Auger Electron Spectroscopy

Monte Carlo method for calculating the radiation skyshine produced by electron accelerators

A scatter correction method for Multi-MeV Flash Radiography

The Monte Carlo Simulation of the High Energy Ions Transport in Materials

Study on Photon Dose of Ultra-intense and Ultra-short Laser Facility Based on Fully Monte-Carlo Simulation

Cavity ionization chamber responses in the JAEA and the NMIJ high-energy photon reference fields for radiation protection

CALCULATION FOR THE RADIATION DOSE DISTRIBUTION AND THE IMPACT OF SCATTERER ON RADIATION DOSE IN A 60Co CONTAINER INSPECTION HALL USING MONTE CARLO METHOD

WE-E-18A-06: To Remove Or Not to Remove: Comfort Pads From Beneath Neonates for Radiography

Analysis of Corrected Cerenkov Emission During Electron Radiotherapy by Monte Carlo Method.