Experimental Study on Dynamic Flexural-Tensile Mechanical Behavior of Wet Sieving Concrete of Xiaowan Arch Dam

苏盛,陈厚群,周继凯,吴胜兴

2010-01-01

Abstract:The experiment on dynamic flexural-tensile mechanical behavior of wet sieving concrete for the Xiaowan Arch Dam was carried out.The test was performed by using the third point loading method for simply supported beam with MTS322 testing machine.In the static loading tests,the loading rate was 250N/s.In the dynamic loading tests,different initial static load(90%,80%,40%and 0%)and different dynamic load patterns(impact wave and triangle wave with variable amplitude),were considered.When the initial static loads were 90%、80%and 40%,the corresponding load values were 41.8kN、37.2kN and 18.6kN respectively.After the initial static loads were reached at the static loading rate,the dynamic load was imposed.The loading rate of the impact wave was 250kN/s.The frequency of the triangle wave is 1Hz,each loading step contains three periods,and loading step increment is 20 kN.The results of wet sieving concrete experiment were as follows:(1)The initial static load has significant effect to the ultimate dynamic flexural-tensile strength of concrete.(2)A proper proportion initial static load is beneficial to the strength,and when the initial static loads were 80%,the DIF of the ultimate dynamic flexural-tensile strength is the largest and is 1.49 in the impact test.(3)Compared with the static loading tests,the ultimate dynamic flexural-tensile strength increases,the ultimate dynamic flexural-tensile strains decrease a little,and the dynamic tensile Young's modulus increases a little,while the position of the neutral axis of normal section in pure bending part does not change in the impact tests.(4)Cyclic load has disadvantageous effect of low cycle fatigue.Comparative analysis of the dynamic flexural-tensile mechanical behavior of fully-graded concrete and wet sieving concrete shows that the relation is similar qualitatively and is not explicit in quantitate,so the dynamic test results of fully-graded concrete should be used in the seismic design of high arch dams.