Abstract:The experiment on dynamic flexural-tensile mechanical behavior of wet sieving concrete for the Xiaowan Arch Dam was carried out.The test was performed by using the third point loading method for simply supported beam with MTS322 testing machine.In the static loading tests,the loading rate was 250N/s.In the dynamic loading tests,different initial static load(90%,80%,40%and 0%)and different dynamic load patterns(impact wave and triangle wave with variable amplitude),were considered.When the initial static loads were 90%、80%and 40%,the corresponding load values were 41.8kN、37.2kN and 18.6kN respectively.After the initial static loads were reached at the static loading rate,the dynamic load was imposed.The loading rate of the impact wave was 250kN/s.The frequency of the triangle wave is 1Hz,each loading step contains three periods,and loading step increment is 20 kN.The results of wet sieving concrete experiment were as follows:(1)The initial static load has significant effect to the ultimate dynamic flexural-tensile strength of concrete.(2)A proper proportion initial static load is beneficial to the strength,and when the initial static loads were 80%,the DIF of the ultimate dynamic flexural-tensile strength is the largest and is 1.49 in the impact test.(3)Compared with the static loading tests,the ultimate dynamic flexural-tensile strength increases,the ultimate dynamic flexural-tensile strains decrease a little,and the dynamic tensile Young's modulus increases a little,while the position of the neutral axis of normal section in pure bending part does not change in the impact tests.(4)Cyclic load has disadvantageous effect of low cycle fatigue.Comparative analysis of the dynamic flexural-tensile mechanical behavior of fully-graded concrete and wet sieving concrete shows that the relation is similar qualitatively and is not explicit in quantitate,so the dynamic test results of fully-graded concrete should be used in the seismic design of high arch dams.

Analysis of Prototype Dynamic Test of Concrete Arch Dams at Home and Abroad

Study on Deformation-Based Seismic Performance Index of Arch Dams

Dynamic analysis of Xiluodu arch dam

Nonlinear dynamic analysis of Dagangshan arch dam with considering damper reinforcement

Field Test and Analysis for the Static and Dynamic Behaviour of Multi-Box Steel Concrete Composite Girder Bridge

Study on Finite Element Analysis of Arch Dam by Deformation Assumptions Based on of Arch-beam Load-distributed Method

The Dynamic Analysis of Arch Dam-Abutment Stability

Experimental Study of Dynamic Properties of Materials of a Faced Rockfill Dam

Model Tests and Numerical Analyses of the Nonlinear Seismic Behavior of Arch Dams with Reinforced Contraction Joints

Experimental Study on Dynamic Flexural-Tensile Mechanical Behavior of Wet Sieving Concrete of Xiaowan Arch Dam

Research on Geomechanical Model of Rupture Tests of Arch Dams for Their Stability

Dynamic Response Analysis for a Complex Dam with High Retaining Walls

A CENTRIFUGE TEST FOR THE DYNAMIC STABILITY OF ARCH DAM–ABUTMENT SYSTEMS

Analysis on Reinforcement across Transverse Joints for Xiaowan Arch Dam to Resist Strong Earthquake

Flexural-tensile testing of fully-graded concrete in static and dynamic states for high arch dam

Test & Study of Structural Properties of High RCC Arch Dam with Different Joint Formations

Study on the dynamic interaction between an arch dam and its appurtenant structures

Geomechanical model test for stability analysis of high arch dam based on small blocks masonry technique

Research on Seismic Failure Pattern of Arch Dam with Contraction Joints by Shaking Table Tests and Numerical Analysis

Global Stability of Yangfanggou Arch Dam by 3D Nonlinear FEM Analysis and Geomechanical Model Tests

Analysis of traveling wave effect of random earthquakes on arch dams