Abstract:The effect of saturation coupled with loading rate on the behavior of dam concrete was investigated under the biaxial compression. Dynamic biaxial compressive experiments on dam concrete cubes with an edge length of 250mm (dry and saturated) were carried out using a large static and dynamic triaxial electro-hydraulic servo multiaxial testing system. The specimens were loaded in biaxial compressive stress states (with the stress ratios of 0:1, 0.25:1, 0.5:1, 0.75:1 and 1:1 respectively) under static and a series of dynamic loading velocities (with strain rates ranging from 10−5/s to 10−2/s). The ultimate strengths of dry and saturated concretes were found to increase with the increase of strain rate, while the damage pattern and ultimate strength are closely related to the magnitude of lateral pressure exerted on the specimen. In addition, the dynamic failure criterion is proposed to characterize both the effects of strain rate and water content on the ultimate strength of dam concrete under biaxial compressive stress states. By testing dry and saturated specimens, the effect of water content on concrete strength was also examined. The experimental results indicate that the static compressive strengths of saturated concrete are lower than those of concrete in dry state, but on the contrary the dynamic strengths of saturated concrete is higher than those of concrete in dry state. The strain rate effect on strength of saturated concrete is more significant than that of dry concrete in lateral confining pressure, indicating that the saturated concrete is more rate-sensitive than dry concrete. As explained through a basic mechanical analysis, this dissimilarity is mainly attributed to the inertia effect and the viscosity of pore-water inside the saturated concrete during fast (quasi-static or dynamic) loading.

Comparison Between Mechanical Properties of Dam and Sieved Concretes

Effect of Aggregate Type on Mechanical Behavior of Dam Concrete

Mesoscopic numerical test of crushing process of concrete under uniaxial compression

Experimental study on fracture properties of self-compacting concrete

Fracture Parameters of Site-Cast Dam and Sieved Concrete

Numerical Simulation of Fracture and Damage Behaviour of Concrete at Different Ages

Experimental investigation on the effect of coarse aggregate size and silica fume dosage to the fracture parameters of concrete

Relationship Between Characteristic Tensile Strain and Curing Age of Concrete

Modeling on mechanical properties of concrete based on cement hydration degree

Fracture Toughness And Microstructure Of Concrete At Early-Ages

Numerical simulation of cracking of early-age concrete three-point beams

Experimental Study of Size Effect on Static/Dynamic Flexural-Tensile Strength of Three-Graded Concrete

Fracture Behavior of Site-Casting Dam Concrete

Influence of Strain Rate and Water Content on Mechanical Behavior of Dam Concrete

Determination of Dam Concrete Strength Parameters Considering the Effects of Ambient Environment, Member Size and Aggregate Size: A Case Study of Baihetan Dam

Comparison of Compressive, Tensile, and Flexural Creep of Early-Age Concretes under Sealed and Drying Conditions

Influence of free water on dynamic behavior of dam concrete under biaxial compression

Experimental Study on the Complete Stress-Deformation Curve of Full Grade Concrete under Axial Tension

EXPRIMENTS FOR DETERMING THE DOUBLE-K FRACTURE PARAMETERS OF CONCRETE OF THE THREE GORGES DAM

Age and Crack Length Effects on Fracture Parameters of Dam Gallery Concrete: Experimental Investigation and Modeling

Large-Beam Tests on Mechanical Behavior of Dam Concrete under Dynamic Loading