Abstract:In the present study, detailed experimental measurements of a large-droplet spray nozzle under a wide range of operating conditions have been conducted at China Aerodynamics Research and Development Center (CARDC) low-speed vertical wind tunnel facility. The droplet size distributions obtained from these measurements have been modelled using the Rosin-Rammler distribution. A multi-physics multi-phase numerical model for the simulation of the complex spray dynamics associated with the large-droplet spray nozzle has been developed in order to support the performance characterization of this device. More specifically, the primary breakup of liquid (water) in the atomizer-produced spray is modelled using a volume of fluid (VOF) to discrete phase model (DPM) transition representation. The numerical model is validated using the experimental measurements. The small relative error between the numerical predictions and experimental measurements for the droplet size distribution and for a number of characteristic droplet diameters suggest that the numerical model provides accurate high-fidelity predictions of the spray dynamics of the large-droplet spray nozzle. Moreover, it is shown that a simple modification of the spray nozzle (increasing the length of the mixing chamber by 50%) has a significant effect on the performance of the nozzle. In particular, the droplet median volumetric diameter and the spray angle are increased as the air pressure is decreased. Furthermore, an increase in the nozzle mixing chamber length results in a much broader droplet size distribution. The validated VOF-to-DPM transition model developed in this study can be used for a future redesign (involving modifications of some key geometric parameters) of the original large-droplet spray nozzle to generate reliably and robustly larger droplets required to simulate various supercooled large droplet conditions of practical relevance.

Experimental Study on Atomization and Drop-Size Distribution of Liquid-Liquid Systems

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Atomic Force Microscopy Study of Non-DLVO Interactions Between Drops and Bubbles.

Hydrodynamics and Heat Transfer in a Fluidized Bed with Liquid Spray: Particle Color-Change Based Measurement and Modelling

Distribution and Movement of Fine Particles Injected in a Gas–solid Fluidized Bed with Hydrocarbon Liquid Spray

EFFECTS OF LIQUID PROPERTIES ON DROP MEAN DIAMETER IN EFFERVESCENT ATOMIZATION SPRAY

Experimental Study of Drop Size Distribution in the Bag Breakup Regime

Experimental Investigation of the Sedimentation Behavior of Metal Droplets in Liquid–liquid Systems

Spray Trajectory and 3D Droplets Distribution of Liquid Jet in Crossflow with Digital Inline Holography

Three-Dimensional Simulation Of Effervescent Atomization Spray

Study on Experimental Test Environment of Atomization Nozzle's Droplet Diameter Distribution

Internal mixing air-assisted spray nozzle for large droplets: Experimental measurements and numerical simulations

In-situ measurement of droplet size distribution by light scattering method

An Experimental Study of Immiscible Liquid–liquid Dispersions in a Pump–mixer of Mixer–settler

Experimental Investigation of Surface Acoustic Wave Atomization

An Experimental Study on Single Drop Rising in a Low Interfacial Tension Liquid–liquid System

Effect of drop size on the impact thermodynamics for supercooled large droplet in aircraft icing

Study on aerodynamic breakup of non-Newtonian liquid droplets and the distribution characteristics of their sub-droplets

Industrial-scale experimental study of internal-mixing air-blast nozzle for sludge atomization