Abstract:Tunnelling is one of the major construction methods to sustain the increasing demand on development in cities. Although many studies have been carried out to investigate the active failure mechanism of tunnel face in sand, the study of passive failure of tunnel face is relatively rare and most of studies are analytical solutions based on the upper bound theorem. In this paper, centrifuge model tests and three-dimensional finite element analyses have been conducted to study the passive failure mechanisms of tunnel face in sand for tunnels located at cover over diameter (C/D) ratios equal to 2.2 and 4.3. Passive failure pressures of tunnel face as well as ground surface displacements were investigated in centrifuge tests. From both centrifuge and numerical investigations, it is found that for a tunnel located at CID ratio equals to 2.2, the soil in front of the tunnel face is displaced by the advancing tunnel face while the soil further away from the tunnel face is forced upwards to the ground surface. A funnel-type failure mechanism is observed and the extent of the failure mechanism is narrower than a five-block failure mechanism commonly assumed in an existing upper bound solution. However, the calculated passive failure pressure by the upper bound solution is fairly consistent with the measured face pressure. It is observed that the funnel-type failure mechanism induces surface heaves. Both observed longitudinal and transverse heaves are well described by Gaussian distributions. For a tunnel located at CID ratio equals to 4.3, the displacements of soil are confined around the vicinity of an advancing tunnel face and a localised failure mechanism associated with ground settlement is observed and computed. There is a large discrepancy between the localised failure mechanism and the five-block failure mechanism. The calculated failure face pressure is higher than the corresponding measured value by 50%. However, reasonable consistency can be found between measured and computed passive face pressures. (C) 2011 Elsevier Ltd. All rights reserved.

Numerical simulation of EPB tunnel face instability in dry sand by discrete element method

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Discrete Element Method for Analysis of Supporting Force for Epb Shield in Dry Sand

Face Stability Analysis of Shallow Shield Tunnels in Dry Sandy Ground Using the Discrete Element Method

Face stability analysis of shield-driven tunnels shallowly buried in dry sand using 1-g large-scale model tests

Model test and discrete element method simulation of tunnel face stability in sand-gravel inclined layered stratum

An Implementation Of Finite Differential Calculation On Tunnel Face Stability

Numerical Research on the Influence of Stress Release on Tunnel Face Stability

Face Stability of Shallow Shield Tunnels in Dry Sandy Ground: Model Tests, Discrete Element Method Simulations and Theoretical Model

A particle-scale insight into the face stability of shallow EPB shield tunnels in dry cobble-rich soil

Soil disturbance induced by EPB shield tunnelling in multilayered ground with soft sand lying on hard rock: A model test and DEM study

Review on Numerical Simulation of the Internal Soil Erosion Mechanisms Using the Discrete Element Method

Experimental study on face instability of shield tunnel in sand

Centrifuge and Numerical Investigation of Passive Failure of Tunnel Face in Sand

Face stability conditions in granular soils during the advancing and stopping of earth-pressure-balanced-shield machine

DEM–FEM Analysis of Soil Failure Process Via the Separate Edge Coupling Method

Numerical simulation of compacted failure in porous sandstone based on discrete element method

A New Approach to DEM Simulation of Sand Production

Numerical study on spalling failure of rock surrounding deep buried tunnel based on DEM

Discrete Element Modelling of a Soil-Rock Mixture Used in an Embankment Dam

Model Design and Application for Excavation Face Stability in Upward Shield Tunneling