Abstract:In the process of hot-dip galvanizing, some beneficial alloying elements are deliberately added to the molten Zn bath, in order to improve the coating properties, such as formability and corrosion resistance. Sb is one of the interesting alloying additions to the Zn bath, as it can decrease the viscosity and the surface tension of the molten Zn, contributing to producing a uniform Zn coating. Due to the low solid solubility of Sb in molten Zn at galvanising temperature, Sb-rich intermetallic particles were always found in the galvanized layers. The presence of Sb-rich phases may affect the structural properties and corrosion performance of galvanized coating. In the literature, it was reported that small addition of Sb has no significant effect on the structure and growth of galvanized layers, but a higher amount (>1%, mass fraction) of Sb can promote the dendritic solidification of Zn. In order to understand the mechanism of Sb addition on the structure and growth of galvanized coating, it is essential to identify the crystal structure of Sb-rich phases. It was reported that the Sb-rich phases found in the eta layer of a galvanized coating corresponds to the electron diffraction patterns of Sb2Zn3. However, some researchers hold that the Sb2Zn3 compound does not exist at room temperature, since it can transform to Sb3Zn4 and Zn at some elevated temperature. Consequently, in this work, the structure of Sb-rich intermetallic phase in theZn-1.2Sb (1.2%Sb) alloy has been investigated by SEM and TEM. SEM/EDS showed that Sb is present in the form of Sb-rich intermatallic phase and there is no detectable Sb in the Zn solid solution. Transmission electron diffractions analysis and EDS results indicated that the composition of Sb-rich intermatallic phases is close to that of Sb2Zn3, whereas the structure is totally different from the latter. The corrosion resistance of Zn-1.2Sb alloy has been analysed by electrochemcial polarization measurements in the different solutions. The analysed results showed that the Sb-rich phase has no obvious effect on the oxygen reduction reaction, in the aerated 0.1 mol/L NaCl (pH=6.5) solution. However, the Sb-rich phase can promote the hydrogen evolution reaction, in the deaerated acidic solution (0.1 mol/L NaCl, pH=3). Corrosion pits were found in the Zn matrix around the Sb-rich phases by SEM observations, which indicate that Zn has higher activity than Zn-Sb phase.

Solidification microstructure of Zn-(0-6.0%)Al-4%Sb alloys used for hot-dip galvanizing

The Microstructure and Mechanical Properties of As-cast Mg-10Gd-3Y-xZn-0.6Zr (x=0, 0.5, 1 and 2 Wt%) Alloys

Effect of Cooling Rate on Solidification Structure of Zinc-Aluminum-Magnesium Alloy

Microstructure and Corrosion Resistance of Solidified Zn-Al-Mg Alloys

Microstructure, phase evolution and corrosion behaviour of the Zn–Al–Mg–Sb alloy coating on steel

Effect of Al Content on the Microstructure and Properties of Zn-Al Solder Alloys

TEM Study on the Microstructure of the Zn-Al-Mg Alloy

The Solidification and Corrosion Behavior Determination of the Ti/B Added Zn-Al-Mg Alloys

Effects of Al contents on microstructure and properties of hot-dip Zn-Al alloy coatings on hydrogen reduced hot-rolled steel without acid pickling

Effect of Sb-Rich Intermetallic Phase on the CorrosionResistance of Zn Alloy in Near-Neutral and Acidic Solutions

Solidification Paths and Phase Components at High Temperatures of High-Zn Al-Zn-Mg-Cu Alloys with Different Mg and Cu Contents

Experimental Investigation and Kinetic Analysis of Al–Zn–Mg Alloy Coating

Crystal structure and microstructure of rapidly solidified La(Ni, Sn)(5+x)(x=0.1-0.4) hydrogen storage alloys

Microstructure and Corrosion Resistance Property of a Zn-AI-Mg Alloy with Different Solidification Processes

Study on the Microstructure of Mg-4Zn-4Sn-1Mn-xAl As-Cast Alloys

Effects of Al Concentration on Microstructure and Mechanical Properties of Mg-xAl-1Zn-1Si Alloy

The Effect of Cooling Rate on the Microstructure and Mechanical Properties of Mg–Zn–Gd-based Alloys

Effect of Al addition on microstructure and mechanical properties of Mg−Gd−Zn alloys

Research on design and microstructure of hot-dip Zn-Al-Mg/Sn alloy

Microstructure, Mechanical Properties and Corrosion Behaviors of Al–Li–Cu–Mg–Ag–Zn Alloys

Analysis of the microstructural evolution and solidification behaviour of Sn-9 wt% Zn alloy with small additions of Mg