Abstract:The development of the space-air-ground integration has put higher demands on satellite network. It needs to support high-bandwidth, large-capacity and various quality of service guarantees. However, the satellite onboard switching is facing the problem of resource constraints and special requirements of hardware complexity and scheduling efficiency. For this, this paper proposes a novel memory architecture for high-bandwidth onboard switching fabric. To reduce hardware complexity, multiplexer is used in the input side to merge k input ports into one internal bus, while the output demultiplexer splits an internal bus into k output links. Shared memory architecture is adopted in the input module to improve the memory efficiency, and a buffered crossbar is used to interconnect the input modules to the output modules. A discrete-time queuing model is formulated, and an iterative approach is used to quantitatively analyze the performance of the proposed architecture. The numerical results can serve as a guidance on deciding the required buffer size. This work is validated by both simulations and FPGA implementations. Synthesize result show that using the state-of-the-art Xilinx VU13P FPGA, a switching fabric with 48 ports can be implemented and the peak throughput of the proposed architecture can reach 480 Gbps. Compared with existing combined input-crosspoint queuing, the proposed architecture can significantly reduce the packet delay and the memory resource cost.

VLSI design of HW/SW interface logic in FC-2

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

Mixed Optimization Method In Design Of Fc-2

Design of Multi-serial Communication for Flight Controlling Computer Based on FPGA

Design and Implementation of FPGA Based High-Speed Bus for Control System

High Performance Programmable Interconnect Resource Design Investigation

Design and VLSI Implementation of IP Core of High-Throughput Configurable FFT Processor

The Design of Fpga'S High Speed Configurable Logic Units

Design of dual-gigabit transceiver for fibre channel FC-1 layer

Architecture design and performance analysis of a novel memory system for high-bandwidth onboard switching fabric

An Optimization of VLSI Architecture for DFE Used in Ethernet

A Low-Cost and High-Throughput Virtual-Channel Router with Arbitration Optimization

Design method for fiber channel application system

An Efficient Scheduling Mechanism With Flow-Based Packet Reordering In A High-Speed Network Processor

VLSI Design of an Efficient Reconfigurable FFT Processor and its Application

Design and Evaluation of Virtual Channel-Based Optical-Electrical Interface for Optical Network-on-Chip

Design and Implementation of DDR3 SDRAM Controller

Design and Implementation of a Fibre Channel Target Driver Supporting SCSI

Design of an Interface Circuit in a 2.5gbps Transceiver System

An Optimized Architecture of Cascaded Crossbar Switches in SoC Systems

Design and protocol analyzer verification of the physical coding sublayer based on the FC protocol