Abstract:This article presents a four-lane single-ended transceiver featuring a crosstalk-canceling coding scheme, Fibonacci coding (FC), which supports high-speed transmission over high-density parallel inter-chip channels. In-depth experiments and analyses are presented to evaluate FC’s performance, and the results suggest that the FC scheme can provide significant near-end and far-end crosstalk cancellation (XTC) while maintaining high channel density for high-speed multi-lane inter-chip links. By simulation, an effective data rate of $4\times8.5$ Gb/s is enhanced to $3\times18$ Gb/s by FC for a four-channel link. The transceiver, including an FC codec, a feed-forward equalizer (FFE), and a continuous-time linear equalizer (CTLE), is implemented in 28-nm CMOS. It achieves a data rate density of 0.90 Tb/s/in with an energy efficiency of 1.29 pJ/b and an area of 0.004 mm 2 /lane. The performance of FC is measured on 3.8-mil-spaced four-lane coupled printed circuit board (PCB) microstrips. For the 2-in wires, the peak-to-peak jitter of the received eye is reduced by 45.0% at 10 Gb/s, and the horizontal aperture is broadened to 0.58 UI at a bit error rate (BER) $< 10^{-12}$ by activating the FC scheme and equalizers. For the 5-in wires, the jitter is reduced by 43.9% and the eye is 0.47-UI-wide at 8.5 Gb/s. And for the 8-in wires, the jitter is reduced by 49.0% and the eye is 0.43-UI-wide at 6 Gb/s.

Design of dual-gigabit transceiver for fibre channel FC-1 layer

A design of fibre channel node with PCI interface

Design of Fibre Optic High-Speed Transmit-Receive Module of Data Acquisition Card

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

An RF/baseband FDMA-interconnect Transceiver for Reconfigurable Multiple Access Chip-to-chip Communication

Design method for fiber channel application system

A Power Efficient 1.0625-3.125 Gb/s Serial Transceiver in 130 Nm Digital CMOS for Multi-Standard Applications.

Design of an In-line Packet Transceiver for 10 Gb/s Ethernet

Design of High-Speed Data Transmission System Based on Fiber Channel

A 10-Gb/s 5-Tap DFE/4-Tap FFE Transceiver in 90-Nm CMOS Technology

Design of High-speed Data Transmission System Based on cPCI Bus

Design and Implementation of a Fibre Channel Target Driver Supporting SCSI

Development of High Performance Optical Transceiver Module Applied in Fiber Channel

A 40 Gb/s SerDes Transceiver Chip with Controller and PHY in a 65 Nm CMOS Technology

Design and protocol analyzer verification of the physical coding sublayer based on the FC protocol

A 0.90-Tb/s/in 1.29-Pj/b Wireline Transceiver with Single-Ended Crosstalk Cancellation Coding Scheme for High-Density Interconnects.

A Fully Integrated CMOS Gigabit Ethernet Serialize & De-Serialize Transceiver Chip

A 10Gb/s 5-Tap-DFE/4-Tap-FFE Transceiver in 90nm CMOS

Realization of High-speed Data Fibre-optical Transmission Based on cPCI Bus

An 11.05 Mw/Gbps Quad-Channel 1.25-10.3125 Gbps Serial Transceiver With A 2-Tap Adaptive Dfe And A 3-Tap Transmit Ffe In 40 Nm Cmos

Fiber channel adapter using FPGA