Abstract:Starting with the initial design stage, the ship resistance constitutes one of the most important hydrodynamic aspects. In order to generate and optimize the body lines plan, the ship resistance performance must be considered. In this case, both numerical and experimental methods must be applied to obtain the minimum ship resistance controlled by the speed domain. In the last years, numerical studies based on the Computational Fluid Dynamic (CFD) were implemented in the initial ship design stage in order to analyse the free-surface flow and to predict the ship resistance. The numerical optimization process of the hull forms must be validated by means of the experimental model tests in the specific towing tanks. The constant evolution of the numerical and experimental methodologies can be noted. As a consequence, the accuracy level of the ship resistance prediction is increased; though, difficult numerical problems can occur in case of the unconventional hull forms. Taking into account this aspect, a complex numerical and experimental investigation of the ship resistance problem and free-surface topology was performed in the case of the DTMB surface combatant. A parallel numerical simulation was carried out by using the viscous flow solver ISIS–CFD of the software FINE TM /Marine provided by NUMECA. The solver is based on the finite volume method to build the spatial discretization of the transport equation to resolve the Reynolds-Averaged Navier Stokes (RANS) equation. Closure to turbulence is achieved by making use of the k-ω SST model, while the free-surface is captured through an air-water interface based on the Volume of Fluid (VOF) method. For the validation purpose, the tank conditions are reintroduced in the numerical model to account for any banking effect, especially for the high speed cases. Experimental model tests were performed in accordance with the ITTC standard procedures, while the extrapolation process to the full-scale was obtained by using an in-house code, based on the ITTC 57 method. The experimental results are compared through with some internationally recognized towing tank experiments that have been performed for a similar ship model, showing a good agreement. Also, the numerical results are validated against the experimental data and showed to be within a satisfactory congruence.

Experimental Investigation of Resistance of a 600 Dwt Deep-Vee Vessel

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

Experimental Study on Dynamical Characteristics of Ship Lift System

Model Analysis of Green Water Phenomena and Loading for Ship Sailing with Slow Speed

Performance evaluation on the designed v-shaped monohull ship models

Experimental and numerical investigation on the ultimate strength of a ship hull girder model with deck openings

Comparative investigations on hull line optimization based on traditional and fully parametric methods for saving energy

Effects of design and fabrication of segmented ship models on test results of wave-induced loads

Design Optimization of the Lines of the Bulbous Bow of a Hull Based on Parametric Modeling and Computational Fluid Dynamics Calculation

Numerical and Experimental Investigation on the Free-surface Flow and Total Resistance of the DTMB Surface Combatant

Investigating Resistance of a Range of Trimaran Designs

Numerical Investigation on a High-Speed Transom Stern Ship Advancing in Shallow Water

The Effect of Hull Form Parameters on the Hydrodynamic Performance of a Bulk Carrier

Multi-objective Optimization of Ship Stern under Static and Seismic Loading

Vibration Response Analysis of a New Scientific Research Ship Based on Finite Element Modeling

Research on Hull Form Design and Numerical Simulation of Sinkage and Trim for a New Shallow-Water Seismic Survey Vessel

Analysis of the overall structural strength and optimization recommendations for ultra-large container ships based on the improved equivalent design wave method

Ship Optimization Based on Fully-Parametric Models for Hull, Propeller and Rudder

Research on Mesh Generation Effecting Resistance Calculation

Investigation on the Effect of Container Configurations and Forecastle Fairings on Wind Resistance and Aerodynamic Performance of Large Container Ships

Experimental Assessment of Vertical Shear Force and Bending Moment in Severe Sea Conditions