Abstract:Starting with the initial design stage, the ship resistance constitutes one of the most important hydrodynamic aspects. In order to generate and optimize the body lines plan, the ship resistance performance must be considered. In this case, both numerical and experimental methods must be applied to obtain the minimum ship resistance controlled by the speed domain. In the last years, numerical studies based on the Computational Fluid Dynamic (CFD) were implemented in the initial ship design stage in order to analyse the free-surface flow and to predict the ship resistance. The numerical optimization process of the hull forms must be validated by means of the experimental model tests in the specific towing tanks. The constant evolution of the numerical and experimental methodologies can be noted. As a consequence, the accuracy level of the ship resistance prediction is increased; though, difficult numerical problems can occur in case of the unconventional hull forms. Taking into account this aspect, a complex numerical and experimental investigation of the ship resistance problem and free-surface topology was performed in the case of the DTMB surface combatant. A parallel numerical simulation was carried out by using the viscous flow solver ISIS–CFD of the software FINE TM /Marine provided by NUMECA. The solver is based on the finite volume method to build the spatial discretization of the transport equation to resolve the Reynolds-Averaged Navier Stokes (RANS) equation. Closure to turbulence is achieved by making use of the k-ω SST model, while the free-surface is captured through an air-water interface based on the Volume of Fluid (VOF) method. For the validation purpose, the tank conditions are reintroduced in the numerical model to account for any banking effect, especially for the high speed cases. Experimental model tests were performed in accordance with the ITTC standard procedures, while the extrapolation process to the full-scale was obtained by using an in-house code, based on the ITTC 57 method. The experimental results are compared through with some internationally recognized towing tank experiments that have been performed for a similar ship model, showing a good agreement. Also, the numerical results are validated against the experimental data and showed to be within a satisfactory congruence.

Performance evaluation on the designed v-shaped monohull ship models

Research on the Hydrodynamic Performance of a Pentamaran in Calm Water and Regular Waves

Model Analysis of Green Water Phenomena and Loading for Ship Sailing with Slow Speed

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

The Analysis Method of Performance Comprehensive Performance Optimization Design for Multi-body Unmanned Boat

Experimental Investigation of Resistance of a 600 Dwt Deep-Vee Vessel

Ship Optimization Based on Fully-Parametric Models for Hull, Propeller and Rudder

Comparative investigations on hull line optimization based on traditional and fully parametric methods for saving energy

Performance of Rescue Boat Operation when Operated in Waves

Effects of design and fabrication of segmented ship models on test results of wave-induced loads

Advancing Interceptor Design: Analyzing the Impact of Extended Stern Form on Deep-V Planing Hulls

Hydrodynamic Decomposition-Based Optimization of Ship’s Hull–Propeller System Under Multiple Operating Conditions

Computational Analysis of the Effect of Hull Vane on Hydrodynamic Performance of a Medium-speed Vessel

Numerical and Experimental Investigation on the Free-surface Flow and Total Resistance of the DTMB Surface Combatant

Analysis Of The Effect Of Side Hull Position On Rolling Motion Characteristics On Trimaran Ship

Fluid Dynamic Simulation of Sail Design Performance on Sail-Assisted Ship; A Preliminary Study

Investigation of An Inverted Bow on Frigate Hull Resistance

Multi-objective Optimization of Ship Stern under Static and Seismic Loading

Analysis of plated-hull structure strength against hydrostatic and hydrodynamic loads: A case study of 600 TEU container ships

Research on Hull Form Design and Numerical Simulation of Sinkage and Trim for a New Shallow-Water Seismic Survey Vessel

Numerical analysis on the seakeeping performances of a full-scale container ship hull using strip theory