Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Experimental Study on Steam Condensation in Horizontal Microchannels

Theoretical and Experimental Research on Flow Boiling Heat Transfer in Microchannels for IGBT Modules

Experimental investigation on interface characteristics and heat transfer during bubble condensation in narrow rectangular channel

Visualization Experiment of Condensation in Expansion and Contraction Microchannels

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental study on condensation of FC-72 in narrow rectangular channel with ellipse-shape pin fins in microgravity

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel

Experimental study of the effect of non-condensable gases on steam condensation over a vertical tube external surface

Experimental investigation of heat transfer in flat plates with rectangular microchannels

Experimental study on heat transfer characteristics of steam underwater direct-contact condensation

Flow Boiling in Vertical Narrow Microchannels of Different Surface Wettability Characteristics

Experimental Investigation On Flow Condensation Heat Transfer In Microtube

Experimental Investigation of Condensation in Micro-Fin Tubes of Different Geometries

Microscale Boiling Heat Transfer in A Micro-Timescale at High Heat Fluxes

Heat Transfer and Pressure Drop During Condensation of R152a in Circular and Square Microchannels

Numerical Simulation of Flow Patterns and the Effect on Heat Flux During R32 Condensation in Microtube

Simulation of Condensation Flow in A Rectangular Microchannel

Numerical simulation of boiling behavior in vertical microchannels

Interfacial Characteristics of Steam Jet Condensation in Crossflow of Water in a Vertical Pipe