Effects of cationic polymer on start-up and granulation in upflow anaerobic sludge blanket reactors
Ying Wang,Kuan‐Yeow Show,Joo‐Hwa Tay,Kwee‐Hock Sim,Kuan-Yeow Show,Joo-Hwa Tay,Kwee-Hock Sim
DOI: https://doi.org/10.1002/jctb.961
IF: 3.709
2004-02-18
Journal of Chemical Technology and Biotechnology
Abstract:The upflow anaerobic sludge blanket (UASB) has been used successfully to treat a variety of industrial wastewaters. It offers a high degree of organics removal, low sludge production and low energy consumption, along with energy production in the form of biogas. However, two major drawbacks are its long start‐up period and deficiency of active biogranules for proper functioning of the process. In this study, the influence of a coagulant polymer on start‐up, sludge granulation and the associated reactor performance was evaluated in four laboratory‐scale UASB reactors. A control reactor (R1) was operated without added polymer, while the other three reactors, designated R2, R3 and R4, were operated with polymer concentrations of 5 mg dm−3, 10 mg dm−3 and 20 mg dm−3, respectively. Adding the polymer at a concentration of 20 mg dm−3 markedly reduced the start‐up time. The time required to reach stable treatment at an organic loading rate (OLR) of 4.8 g COD dm−3 d−1 was reduced by more than 36% (R4) as compared with both R1 and R3, and by 46% as compared with R2. R4 was able to handle an OLR of 16 g COD dm−3 d−1 after 93 days of operation, while R1, R2 and R3 achieved the same loading rate only after 116, 116 and 109 days respectively. Compared with the control reactor, the start‐up time of R4 was shortened by about 20% at this OLR. Granule characterization indicated that the granules developed in R4 with 20 mg dm−3 polymer exhibited the best settleability and methanogenic activity at all OLRs. The organic loading capacities of the reactors were also increased by the addition of polymer. The maximum organic loading of the control reactor (R1) without added polymer was 19.2 g COD dm−3 d−1, while the three polymer‐assisted reactors attained a marked increase in organic loading of 25.6 g COD dm−3 d−1. Adding the cationic polymer could result in shortening of start‐up time and enhancement of granulation, which may in turn lead to improvement in the efficiency of organics removal and loading capacity of the UASB system. Copyright © 2004 Society of Chemical Industry
engineering, chemical,biotechnology & applied microbiology, environmental,chemistry, multidisciplinary