Abstract:Upflow anaerobic sludge blanket (UASB) reactor that was seeded with anaerobic sludge acclimated to chlorophenols was used to investigate the feasibility of anaerobic biotreatment of synthetic wastewater containing pentachlorophenol (PCP) with additional sucrose as carbon source. Two sets of UASB reactors were operated at one time. But the seeded sludge for the two reactors was different and Reactor I was seeded with the sludge that was acclimated to PCP completely for half a year, and Reactor II was seeded with the mixed sludge that was acclimated for half a year to PCP, 4-CP, 3-CP or 2-CP, respectively. The degradation of PCP and the operation fee treating the wastewater are affected by the concentration of MEDS (microorganism easily degradable substrate). So the confirmation of the suitable ratio of [COD] and [PCP] was the key factor of treating the wastewater containing PCP economically and efficiently. During the experiment, the synthetic wastewater with 180.0mgL−1 PCP and 1250–10000mgL−1 COD could be treated steadily in the experimental Reactor I. The removal efficiency of PCP was more than 99.5% and the removal efficiency of COD was up to 90%. [PCP] (concentration of PCP) in effluent was less than 0.5mgL−1. [PCP] in influent could affect proper [COD] (concentration of COD) range in influent that was required for maintenance of steady running of the experimental reactor with a hydraulic retention time (HRT) from 20 to 22h. [PCP] in influent would directly affect the necessary [COD] in influent when the UASB reactor ran normally and treated the wastewater containing PCP. When [PCP] was 100.4, 151.6 and 180.8mgL−1 in influent, respectively, [COD] in influent had to be controlled about 1250–7500, 2500–5000 and 5000mgL−1 to maintain the UASB reactor steady running normally and contemporarily ensure that [COD] and [PCP] in effluent were less than 300 and 0.5mgL−1, respectively. With the increase of [PCP] in influent, the range of variation of [COD] in influent endured by the UASB reactor was decreasing. The ratios of [COD] and [PCP] in influent could affect removal efficiency of PCP and COD, the concentration of total volatile fatty acids (VFA) in effluent, biogas quantity and methane content in biogas. [PCP] in influent was linearly or semi-logarithmically correlated to [COD] in effluent when [COD] in influent was 5750±250mgL−1, and so was the relationship between [COD] in influent and [PCP] in effluent when [PCP] in influent was 100.4 or 151.6mgL−1, less than the maximum permissible [PCP]. The sources of seeded sludge, the way of sludge acclimation and the characteristics of anaerobic sludge could all affect the UASB reactor capacity treating PCP. When [PCP] were less than 180.8mgL−1 for Reactor I and 151.6mgL−1 for Reactor II, the variation of [PCP] in influent had little effect on the UASB reactor volume gas production rate and substrate gas production rate. And [VFA] and pH value in effluent were affected a little. Volume biogas production rate and substrate biogas production rate of the UASB reactor were only affected by [COD] and loading rate in influent. But when [PCP] was more than 151.6mgL−1 for Reactor II, the biogas production fell quickly and was over 3 days later. [VFA] in effluent from Reactor II increased up to 2198.1mgL−1 quickly and the pH value fell to less than 7. Reactor II could not run normally. The component of VFA accumulated quickly was mainly acetate (above 50%). With [PCP] increased from 7.9 to 180.8mgL−1 gradually in influent, the methane content in biogas from Reactor II decreased from 70% to 60%, but the reactor could still run normally. Then as for Reactor II, the content of methane have fallen from 75% to 45% or so quickly. And Reactor II could not run steadily. So the conclusion could be drown that too high [PCP] in influent for UASB reactor mainly inhibited the activity of methane-producing bacteria cultures utilizing the acetate.

Study on Quick Start-up of Upflow Anaerobic Sludge Blanket Reactor for Treating Cotton Pulp Black Liquor

Effect of Pentachlorophenol and Chemical Oxygen Demand Mass Concentrations in Influent on Operational Behaviors of Upflow Anaerobic Sludge Blanket (UASB) Reactor.

Performance of anammox UASB reactor treating low strength wastewater under moderate and low temperatures

Review of Upflow Anaerobic Sludge Blanket Reactor Technology: Effect of Different Parameters and Developments for Domestic Wastewater Treatment

Characterization and Quantification of Anammox Start-Up in UASB Reactors Seeded with Conventional Activated Sludge

Effects of Added Powdered and Granular Activated Carbons on Start-Up Performance of UASB Reactors

STUDY ON TWO METHODS FOR STARTING UASB DURING THE TREATMENT OF CHLOROMYCETIN WASTEWATER

The Influence of Aerobic Sludge Retention Time on Anaerobic Co-Digestion of Dyeing and Printing Wastewater and Sewage Sludge

Pilot study on the upgrading configuration of UASB-MBBR with two carriers: Treatment effect, sludge reduction and functional microbial identification

Monitoring the Restart-Up of an Upflow Anaerobic Sludge Blanket (UASB) Reactor for the Treatment of a Soybean Processing Wastewater

Preliminary Study on Treatment of Dye Producing Wastewater with Upflow Anaerobic Sludge Blanket

Effects of cationic polymer on start-up and granulation in upflow anaerobic sludge blanket reactors

Anaerobic degradation of pesticide wastewater: Improving sludge characteristics and reducing membrane fouling with combined tandem UASB+membrane system with high velocity settlers

Improving Anammox start-up with bamboo charcoal

Improved stability of up-flow anaerobic sludge blanket reactor treating starch wastewater by pre-acidification: Impact on microbial community and metabolic dynamics

Hydrodynamic behavior and start-up performance of a periodic anaerobic baffled reactor in an "every second" switching manner treating traditional Chinese medicine wastewater

Start-up Strategies of UASB Reactor for Treatment of Pharmaceutical Wastewater.

Effects of Stressed Loading on Startup and Granulation in Upflow Anaerobic Sludge Blanket Reactors

Start-up and Performance Evaluation of Upflow Anaerobic Sludge Blanket Reactor Treating Supernatant of Hydrothermally Treated Municipal Sludge: Effect of Initial Organic Loading Rate

Rapid start-up and excellent performance of anaerobic membrane bioreactor for treating poly (butylene adipate-co-terephthalate) wastewater by using one-step feeding mode

Application of aerobic granular sludge in polishing the UASB effluent.