Abstract:A series of TiO2 supported iron-manganese mixed oxide catalysts were studied for catalytic oxidation of NO to NO2. The oxidation activity was greatly enhanced with the addition of iron, by about 34% at 300 degrees C. Mn0.1Fe0.15/Ti with the molar ration of Mn:Fe = 1:1.5 showed the best oxidation activity. It was also found that the addition of iron oxide increased the resistance to H2O and SO2. The formation of byproduct N2O could generally be disregarded. A combination of various physico-chemical techniques was used to characterize the physical and chemical properties of these catalysts. The surface area did not change very much with the addition of iron. The XRD (X-ray diffraction) and HR-TEM (high-resolution transmission electron microscopy) results suggested that there was an interaction between manganese and iron, leading to the formation of manganese-iron composite oxides, which were in the amorphous phase. The XPS (X-ray photoelectron spectroscopy) and H-2-TPR (temperature-programmed reduction) investigations demonstrated that this composite oxide with an amorphous structure increased the surface active oxygen, facilitated oxygen mobility and enhanced the oxidation-reduction ability over the catalysts, all of which were crucial factors for the increase in NO oxidation activity. The FTIR (Fourier transform infrared spectroscopy) results showed that nitrates worked as intermediates which could be easily decomposed to nitrogen oxides. The introduction of iron into manganese oxides increased the formation of intermediates and reduced the formation of sulfates on the surface of the catalysts.

Manganese-Based Catalysts Supported on Titania for the Oxidation of Nitric Oxide

Influence of the TiO2 Crystalline Phase of MnOx/TiO2 Catalysts for NO Oxidation

Study of the Promotion Effect of Iron on Supported Manganese Catalysts for No Oxidation

MnOx/TiO2 Composite Nanoxides Synthesized by Deposition-Precipitation Method As a Superior Catalyst for NO Oxidation

Low Temperature Selective Catalytic Reduction of NO over Manganese Supported on TiO2 Nanotubes

Mechanism Study Of No Catalytic Oxidation Over Mnox/Tio2 Catalysts

Mn-based catalysts supported on γ-Al 2 O 3 , TiO 2 and MCM-41: a comparison for low-temperature NO oxidation with low ratio of O 3 /NO

Plasma-catalytic High-Efficiency Oxidation of NO over Co-Mn/Ti Catalysts Using Surface Dielectric Barrier Discharge Plasma

Highly dispersed V2O5/TiO2 modified with transition metals (Cu, Fe, Mn, Co) as efficient catalysts for the selective reduction of NO with NH3

Titania-Samarium-Manganese Composite Oxide for the Low-Temperature Selective Catalytic Reduction of NO with NH3

The fabrication of Mn single atoms/clusters on Al2O3 for enhanced catalytic NO oxidation

Manganese-cerium oxide (MnOx-CeO2) catalysts supported by titanium-bearing blast furnace slag for selective catalytic reduction of nitric oxide with ammonia at low temperature

Investigation and Characterization on MnO_x/TiO_2 for Low-Temperature Selective Catalytic Reduction of NO_x with NH_3

Manganese Oxide Catalysts Supported on Zinc Oxide Nanorod Arrays: A New Composite for Selective Catalytic Reduction of NOx with NH3 at Low Temperature

Catalytic Oxidation Activity of NO over Mullite-Supported Amorphous Manganese Oxide Catalyst

Active Manganese Oxide on MnOx–CeO2 Catalysts for Low-Temperature NO Oxidation: Characterization and Kinetics Study

Selective catalytic reduction of NOx with NH3 over Mn–Zr–Ti mixed oxide catalysts

Effect of Calcination Temperature on the Structure and Performance of Mn/Al2O3-TiO2 Catalyst in the Catalytic Oxidation of NO

Advanced Mnox/Tio2 Catalyst with Preferentially Exposed Anatase {001} Facet for Low-Temperature Scr of No

Sm-MnO /TiO2-{001} with preferentially exposed anatase {001} facet for selective catalytic reduction of NO with NH3

Effect of MnO(x) Modification on the Activity and Adsorption of CuO/Ce(0.67)Zr(0.33)O(2) Catalyst for NO Reduction.