Abstract:This paper proposes an opto-electronic co- simulation method to evaluate a fast clock and data recovery (CDR) technique for optically switched data centers. The CDR technique is realized by leveraging a phase updating mechanism and also a global synchronous clock. Briefly, in all-optical networks, by applying a global synchronous clock to both transmitters and receivers, CDR will only need to extract phase delay in the receiver node, and then by compensating the phase delay in the transmitter node, the phase locking-process in RX CDR module can be omitted. This can significantly reduce the CDR locking time. The structure is crucial in supporting server-to-server optical communication but is not sufficiently studied in our perspective. In this paper, we add more analysis to the CDR technique and give circuit-level improvements. The analysis and circuit verifications are conducted by designing a novel opto-electronic co-simulation method, where software Opti-system is employed to carry out optical-related simulations, and MATLAB Simulink is employed to carry out electrical related simulations. We first test the validity of the phase updating mechanism with a specifically designed phase interpolator and a modified bang-bang phase detector. Then we analyze the influence of channel jitters and optical carrier power variations. It’s shown that the CDR technique can tolerate channel deterministic jitter and random jitter of 0.5UI and 0.1UI respectively, and can tolerate a carrier power variation from 0dBm to 2dBm.

A Clock and Data Recovery Method Based on Phase Detector Implemented by Delay Chain in FPGA

Clock Data Recovery Based on Delay Chain for Medium Data Rate Transmission

Design and Implementation of the High-Performance Link Layer in High-Speed Serial Communication

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

10 Gb/s Linear Full-Rate CMOS Phase Detector for Clock Data Recovery Circuit

Non-Sequential Linear Cmos Phase Detector for Cdr Applications

A Novel Clock and Data Recovery Technique Based on Sigma-Delta Phase Quantization

A Novel Clock And Data Recovery Scheme Based On Sigma-Delta Quantization

Sigma-delta based clock recovery using on-chip PLL in FPGA

A New Architecture High Speed Clock and Data Recovery Circuit

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

A speculative clock and data recovery architecture for multi-gigabit/s series links

Clock and Data Recovery for 10-Gb/s EPON Application

A data recovery method for high-speed serial communication based on FPGA

Simultaneous Clock Recovery for 160 Gbit/S Optical Time-Division Multiplexing Signal Using Phase Modulation

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A Low-latency Multi-format Carrier Phase Recovery Hardware for Coherent Optical Communication

Weighted Voting Method of Clock and Data Recovery for Plastic Optical Fiber Signal

Design and Realization of a Clock Phase Interpolator Circuit Based on PLL

Evaluation of a Subnanosecond Clock and Data Recovery Technique Via Matlab Simulink and Opti-System Co-Simulation

Theoretical Modeling and Simulation of Phase-Locked Loop (PLL) for Clock Data Recovery (CDR)