Morphology and properties of PP/PA 6 blends modified by reactive compatibilization

Jie Lan,Bo Yin,Mingbo Yang,Jianmin Feng
DOI: https://doi.org/10.3969/j.issn.1002-1396.2009.03.017
2009-01-01
Abstract:Blends consisting of polypropylene (PP), maleic anhydride grafted PP (PP-g-MAH) and polyamide 6 (PA 6) with different proportions were prepared by lateral injection of compatibilizer and direct compounding process. The impacts of the two compatibilization modes on morphology and properties of the PP/PP-g-MAH/PA 6 blends were studied by mechanical properties testing, scanning electron microscopy and differential scanning calorimetry (DSC). The results reveal that introducing PP-g-MAH can simultaneously improve rigidity and toughness of the PP/PA 6 blends and more specifically, the compatibilization effectiveness of the lateral injection mode is much more remarkable. The tensile strength of the PP/PA 6 blend containing 5 phr PP-g-MAH added in lateral injection mode is 23.6% higher than that of pure PP. The tensile fracture strain of the composite system containing 20 phr PP-g-MAH added in lateral injection mode is over 1 000%. The introduction of PP-g-MAH is able to improve effectively the compatibility in the PP/PA 6 system, raise the interfacial binding force between the two phases and reduce the particle size of the dispersed phase. The lateral injection mode is much more superior in compatibilization effectiveness to direct compounding mode.
What problem does this paper attempt to address?