Effect Of Potassium Sodium Tartrate And Sodium Citrate On The Preparation Of Alpha-Calcium Sulfate Hemihydrate From Flue Gas Desulfurization Gypsum In A Concentrated Electrolyte Solution

Zhuoxian Shen,Baohong Guan,Hailu Fu,Liuchun Yang
DOI: https://doi.org/10.1111/j.1551-2916.2009.03330.x
IF: 4.186
2009-01-01
Journal of the American Ceramic Society
Abstract:Flue gas desulfurization (FGD) gypsum mainly composed of calcium sulfate dihydrate (DH) was used as a raw material to obtain alpha-calcium sulfate hemihydrate (alpha-HH) through dehydration in a Ca-Mg-K-Cl-solution medium at 95 degrees C under atmospheric pressure. The effects of potassium sodium tartrate and sodium citrate on the preparation of alpha-HH in the electrolyte solution were investigated. The results revealed that the addition of potassium sodium tartrate (1.0 x 10-2 -2.5 x 10-2M) decreased the dehydration rate of FGD gypsum and increased the length/width (l/w) ratio of alpha-HH crystals, which could yield unfavorable strength properties. Addition of sodium citrate (1.0 x 10-5 - 2.0 x 10-5M) slightly increased the dehydration rate of FGD gypsum and decreased the l/w ratio of alpha-HH crystals, which could be beneficial to increase strength. However, it also led to a partial formation of anhydrite (AH) crystals. AH was also the only dehydration product when the concentration of sodium citrate increased to 1.0 x 10-4M. Therefore, sodium citrate rather than potassium sodium tartrate could be used as an additive in Ca-Mg-K-Cl electrolyte solutions if alpha-HH with a shorter l/w ratio is the desired product from FGD gypsum dehydration. The concentration of sodium citrate should be properly controlled to reduce the formation of AH.
What problem does this paper attempt to address?