Temperature Dependent Luminescence of Yellow‐Emitting Α‐sialon:Eu2+ Oxynitride Phosphors for White Light‐Emitting Diodes

Lihong Liu,Rong-Jun Xie,Naoto Hirosaki,Takashi Takeda,Jiguang Li,Xudong Sun
DOI: https://doi.org/10.1111/j.1551-2916.2009.03275.x
IF: 4.186
2009-01-01
Journal of the American Ceramic Society
Abstract:Yellow‐emitting α‐sialon:Eu2+ phosphors have been reported as interesting down‐conversion luminescent materials in white LEDs. In this work, the thermal quenching of α‐sialon:Eu2+ with the compositions of Mval+(m/val+)Si12−(m+n)Alm+nOnN16−n (M=Ca, Mg, Lu) is studied by investigating the effects of chemical composition, activator concentration, and substitution cation on the temperature‐dependent luminescence. The chemical composition of α‐sialon:Eu2+ was varied in a wide range (0.5≤m≤2.0, 1≤n≤1.8). It shows that the m value significantly affects the thermal quenching of α‐sialon, whereas the n value hardly does. This difference is ascribed to the obvious lattice expansion and the increase of absolute activator concentration as m increases. The thermal quenching increases with increasing the Eu2+ concentration, which is due to enhanced Stokes shift. The type of substitution cation also has an influence on thermal quenching. Among the substitution cations in this work, Lu‐α‐sialon:Eu2+ exhibits largest thermal quenching. Photoionization is considered as the mechanism for the thermal quenching of Lu‐α‐sialon: Eu2+.
What problem does this paper attempt to address?