Abstract:As the impact of climate change intensifies, meeting the energy demand of buildings in China's cold regions is becoming increasingly challenging, particularly in terms of cooling energy consumption. The effectiveness of integrating phase change material (PCM) into building envelopes for energy saving in China's cold regions is unclear. The aim of this study is to assess the effectiveness of PCM integration in building enclosures for energy efficiency in these regions. The research monitored and recorded indoor temperature data from typical residential cases from May to September. This measured data was then used to validate the accuracy of EnergyPlus22-1 software simulation models. Subsequently, the calibrated model was utilized to conduct a comparative analysis on the effects of PCM on indoor temperatures and cooling energy consumption across these regions. The results of these comparative analyses indicated that PCM can alleviate indoor overheating to varying degrees in severe cold regions of China. Focusing on north-facing bedrooms, applying PCMs reduced the duration of overheating in non-air-conditioned buildings in severe cold regions of China by 136 h (Yichun), 340 h (Harbin), 356 h (Shenyang), and 153 h (Dalian). In terms of cooling energy consumption, the energy saved by applying PCMs ranged from 1.48 to 13.83 kWh/m2. These results emphasize that the performance of PCM varies with climate change, with the most significant energy-saving effects observed in severe cold regions. In north-facing bedrooms in Harbin, the energy-saving rate was as high as 60.30%. Based on these results, the study offers guidance and recommendations for feasible passive energy-saving strategies for buildings in severe cold and cold regions of China in the face of climate change. Additionally, it provides practical guidance for applying PCMs in different climatic zones in China.

The comparative analysis of the effects on the dynamic air-conditioning load of the top floor building by adopting PCM or insulation material

Adjustable Insulation for Enhancing the Performance of Phase Change Materials in Buildings

COMPARATIVE ANALYSIS OF THE EFFECTS OF PCMs AND INSULATION MATERIALS ON ENERGY SAVING IN BUILDINGS LOCATED IN FIVE TYPICAL CITIES

Study on the Optimization of PCM Integrated Air-Conditioning Duct for the Demand Shifting

Study on the Influence of the Application of Phase Change Material on Residential Energy Consumption in Cold Regions of China

Parametric Analysis of Using PCM Walls for Heating Loads Reduction

Experimental Study on the Demand Shifting Effects of PCM Integrated Air-Conditioning Duct

Thermal performance and economy of PCM foamed cement walls for buildings in different climate zones

Parametric analysis of applying PCM wallboards for energy saving in high-rise lightweight buildings in Shanghai

Experimental study of the thermal and energy conservation characteristics of combined phase change material (PCM) room in summer

Parametric and economic analysis of incorporating phase change material (PCM) into exterior walls to reduce energy demand for traditional dwellings in northeast of Sichuan hills, China

Numerical Model of Applying PCM Boards for Energy Saving in Lightweight Buildings in Shanghai

Study on PCM Application in Old Building Energy Efficiency

Energy and economic analysis of a building air-conditioner with a phase change material (PCM)

Experimental study on the performance of a novel RC-PCM-wall

Experimental research on the use of phase change materials in perforated brick rooms for cooling storage

Experimental investigation of PCM transient performance in free cooling of the fresh air of air conditioning systems

Energy reduction of building air-conditioner with phase change material in Thailand

Thermoeconomic analysis of a wall incorporating phase change material in a rural residence located in northeast China

Energy saving performance optimization and regional adaptability of prefabricated buildings with PCM in different climates

Numerical analysis on the energy performance of the PCMs-integrated thermochromic coating building envelopes