Abstract:Phase change materials are used in passive solar house construction with light steel structure walls, which can overcome the problems of weak heat storage capacity and poor utilization of solar heat and effectively solve the thermal defects of light steel structure walls. Based on this, on the basis of preliminary experimental research, this study further carried out theoretical analysis and simulation research on the thermal performance of a light steel structure passive solar house (Trombe form) with PCM walls. Through the heat balance analysis of heat transfer in the heat collecting partition wall, the theoretical calculation formula of the phase change temperature of the PCM was obtained, and it verified theoretically that the phase change temperature value should be 1–3 °C higher than the target indoor air temperature. The evaluation index “accumulated daily indoor temperature offset value” was proposed for evaluating the effect of phase change materials on the indoor temperature of the passive solar house, and “EnergyPlus” software was used to study the influence of the phase change temperature, the amount of material, and the thickness of the insulation layer on the indoor air temperature in a natural day. The results showed that there was a coupling relationship among the performance and between of the thickness of the PCM layer and the phase change temperature. Under typical diurnal climate conditions in the northern Tibetan Plateau of China, the optimal combination of the phase change temperature and the layer thickness was 17 °C and 15 mm, respectively. Especially at a certain temperature, excessive increases in the thickness of the phase transition layer could not improve the indoor thermal environment. For this transition temperature, there exists an optimal transition layer thickness. For a Trombe solar house, the thickness of the insulation layer has an independent impact on indoor temperature compared to other factors, which has an economic value, such as 50 mm in this case. In general, this paper studied the relationship between several important parameters of the phase change wall of a solar house by using numerical simulation methods and quantitatively calculated the optimal parameters under typical meteorological conditions, thus providing a feasible simulation design method for similar engineering applications.

Analysis of temperature regulation and heat storage effect of the combined phase change envelope in hot summer and cold winter zone

STUDY ON CHARGING AND DISCHARGING RATES OF LATENT HEAT THERMAL ENERGY STORAGE SYSTEMS EMPLOYING MULTIPLE PHASE CHANGE MATERIALS

Integrating phase change material in building envelopes combined with the earth-to-air heat exchanger for indoor thermal environment regulation

Analytical Optimization of Interior PCM for Energy Storage in a Lightweight Passive Solar Room

Exploring the Potential of Phase Change Material for Thermal Energy Storage in Building Envelopes

Experimental study of the thermal and energy conservation characteristics of combined phase change material (PCM) room in summer

A parametric model on thermal evaluation of building envelopes containing phase change material

Study on the Influence of the Application of Phase Change Material on Residential Energy Consumption in Cold Regions of China

Effect of melting point on thermodynamics of thin PCM reinforced residential frame walls in different climate zones

Numerical analysis on the energy performance of the PCMs-integrated thermochromic coating building envelopes

Thermal Performance Optimization Simulation Study of a Passive Solar House with a Light Steel Structure and Phase Change Walls

An Assessment of Mixed Type PCM-gypsum and Shape-Stabilized PCM Plates in a Building for Passive Solar Heating

Numerical simulations on the thermal performance of ventilated walls with passive solar heating and latent heat storage in winter

Application of Monodisperse Encapsulated Phase Change Materials in Building Thermal Energy Storage

Thermal performance and economy of PCM foamed cement walls for buildings in different climate zones

Towards Passive Building Thermal Regulation: A State-of-the-Art Review on Recent Progress of PCM-Integrated Building Envelopes

Analytical Optimization of Key Design Parameters of Phase Change Materials Used in Passive Building Envelopes

Parametric Analysis on Performances of the Pipe-Encapsulated PCM (penpcm) Wall System Coupled with Gravity Heat-Pipe and Nocturnal Radiant Cooler

Improving thermal performance of a passive ventilation and cooling system by integrating a phase-change material: Dynamic characteristics and parametric examinations

Effect of thermal parameters on heat storage and release performance of phase change material composite wall

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study