Abstract:Phase change materials (PCMs) are materials that can store large amounts of heat during their phase transition from solid to liquid without a significant increase in temperature. While going from liquid to solid this heat is again released. As such, these materials can play an important role in future energy-efficient buildings. If applied in facades as part of a thermal buffer strategy, e.g., capturing and temporarily storing solar energy in so-called Trombe walls, the PCMs are exposed to high solar radiation intensities, which may easily lead to issues of overheating. This paper therefore investigates the melting process of PCM and arrives at potential solutions for countering this overheating phenomenon. This study uses the simulation program Comsol to investigate the heat transfer through, melting of and fluid flow inside a block of PCM (3 × 20 cm2) with a melting temperature of around 25 °C. The density, specific heat and dynamic viscosity of the PCM are modeled as a temperature dependent variable. The latent heat of the PCM is modeled as part of the specific heat. One side of the block of PCM is exposed to a heat flux of 300 W/m2. The simulations show that once part of the PCM has melted convection arises transporting heat from the bottom of the block to its top. As a result, the top heats up faster than the bottom speeding up the melting process there. Furthermore, in high columns of PCM a large temperature gradient may arise due to this phenomenon. Segmenting a large volume of PCM into smaller volumes in height limits this convection thereby reducing the temperature gradient along the height of the block. Moreover, using PCMs with different melting temperature along the height of a block of PCM allows for controlling the speed with which a certain part of the PCM block starts melting. Segmenting the block of PCM using PCMs with different melting temperature along its height was found to give the most promising results for minimizing this overheating effect. Selecting the optimal phase change temperatures however is critical in that case.

Effect of melting point on thermodynamics of thin PCM reinforced residential frame walls in different climate zones

Adjustable Insulation for Enhancing the Performance of Phase Change Materials in Buildings

Thermal performance and economy of PCM foamed cement walls for buildings in different climate zones

Exploring the Potential of Phase Change Material for Thermal Energy Storage in Building Envelopes

Effects of the position and melting point of the PCM layer on the comprehensive thermal performance of a Trombe wall under mixed dry climate

Evaluating the potential of optimized PCM-wallboards for reducing energy consumption and CO 2 emission in buildings

Energy saving performance optimization and regional adaptability of prefabricated buildings with PCM in different climates

Temperature Control in (Translucent) Phase Change Materials Applied in Facades: A Numerical Study

Study on the Influence of the Application of Phase Change Material on Residential Energy Consumption in Cold Regions of China

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study

Thermoeconomic analysis of a wall incorporating phase change material in a rural residence located in northeast China

Simulation-based optimization of PCM melting temperature to improve the energy performance in buildings

Thermal storage and nonlinear heat-transfer characteristics of PCM wallboard

Numerical study on thermal comfort and energy-saving potential of a prefabricated temporary house integrated with composite phase change materials

Dynamic integration of phase change material in walls for enhancing building thermal performance—A novel self-adaptive method for moving PCM layer

A parametric model on thermal evaluation of building envelopes containing phase change material

Enhancing energy efficiency of PCM wall in winter with novel PCM-DLCB coupling design

A parametric study on the thermal response of a building wall with a phase change material (PCM) layer for passive space cooling

Effect of thermal parameters on heat storage and release performance of phase change material composite wall

Experimental study of breathable and heterogeneous phase change material (B&H-PCM) wall for all-season thermal performance enhancement

Derivation of appropriate temperature change for application of phase change materials in building walls for energy reduction in Korean climatic conditions