Abstract:Prefabricated converter station building has been gradually applied in the field of power engineering construction due to the advantages of standardized design, high construction efficiency, and quality control. The beam–column joint is the essential constitutive part to ensure structural integrity and reliable force transmission for the prefabricated structure. In this paper, a novel load bearing-energy dissipation connection is proposed and applied to the beam–column joint to improve seismic performance and seismic resilience. Pseudo-static tests were conducted on the beam–column joint with the load bearing-energy dissipation connection, and the test results demonstrated that the tested beam–column joints developed with similar failure modes, and the damage was concentrated in the load bearing-energy dissipation connection while the beam and column remained elastic. The beam–column joint with the load bearing-energy dissipation connection had stable hysteresis behavior, with favorable bearing capacity and energy dissipation behavior. A shorter slip length and a larger bolt distance could lead to better stress development and enhance the bearing capacity, while the slip length barely affected the ductile behavior. Moreover, a finite element model was established and validated to extend the parametric study to provide a preliminary understanding of the mechanical mechanism of the proposed beam–column joint with the load bearing-energy dissipation connection. It was confirmed that the load–-deformation behavior was greatly affected by the slip length, but the slip length barely affected the initial stiffness. The width of the sliding steel fuse influenced the bearing capacity and the degradation behavior. A wider width could lead to a higher bearing capacity and improve the degradation behavior. Based on the analysis of the stress development and stress distribution corresponding to different feature points, it was concluded that the use of bearing-energy dissipation improved the stress development in the framing components and achieved damage concentration.

Seismic Behavior and Design Method of Beam-to-column Connections with Beam-End Horizontal Haunches

EXPERIMENTAL STUDY ON THE SEISMIC BEHAVIOR OF CFST RECTANGULAR COLUMN TO H-SECTION STEEL BEAM CONNECTIONS WITH EXTERNAL STIFFENERS

Seismic Behavior of an Improved Drilled Flange Connection for I-beam to CFST Column

Experimental study on seismic behavior of assembled steel beam-PC column composite frames

Seismic Behavior of Exterior Connections with Steel Beams Bolted to Cft Columns

Experimental Research on Seismic Behavior of Reinforced Concrete Column-to-Steel Beam Joints with Bolted End-plate

Seismic Behavior of Wide-Flange Steel Column with Confined Potential Plastic Hinge

Seismic performance of H-section beam to HSS column connection in prefabricated structures

Experimental study and finite element analysis on the new type connections of a project

Design and Numerical Analysis of a Damage-Controllable Mechanical Hinge Beam-to-column Connection

Static and Seismic Experimental Study of Novel Prefabricated Beam-Column Joints with Elongated-Hole Brackets

Seismic Performance of Prefabricated Steel Beam-To-Column Connections

Experimental Research on Seismic Performance of a New-Type of R/C Beam-Column Joints with End Plates

Experimental study on seismic behavior of steel beam to wide-flange specially-shaped composite column connections

Experimental study on the seismic behaviour of the connection between concrete-filled twin steel tubes column and steel beam

Seismic performance of joint between steel H‐beam and rectangular concrete‐filled hot‐rolled‐steel tubular column

Experimental studies of full-scale self-centering beam-to-column exterior connection

Seismic performance of bolted connection between T-shaped section column and I-section beam with L-stubs

Seismic behaviour of steel beam to circular CFST column assemblies with external diaphragms

The Hysteresis Behavior of Steel Beam–Column Joint with the Load Bearing-Energy Dissipation Connection for Converter Station Building

FEM ANALYSIS OF RESISTANCE OF REINFORCED BEAM-TO-COLUMN CONNECTION WITH COVER-PLATE UNDER LOADS IN STEEL FRAME