Abstract:The experiment on dynamic flexural-tensile mechanical behavior of wet sieving concrete for the Xiaowan Arch Dam was carried out.The test was performed by using the third point loading method for simply supported beam with MTS322 testing machine.In the static loading tests,the loading rate was 250N/s.In the dynamic loading tests,different initial static load(90%,80%,40%and 0%)and different dynamic load patterns(impact wave and triangle wave with variable amplitude),were considered.When the initial static loads were 90%、80%and 40%,the corresponding load values were 41.8kN、37.2kN and 18.6kN respectively.After the initial static loads were reached at the static loading rate,the dynamic load was imposed.The loading rate of the impact wave was 250kN/s.The frequency of the triangle wave is 1Hz,each loading step contains three periods,and loading step increment is 20 kN.The results of wet sieving concrete experiment were as follows:(1)The initial static load has significant effect to the ultimate dynamic flexural-tensile strength of concrete.(2)A proper proportion initial static load is beneficial to the strength,and when the initial static loads were 80%,the DIF of the ultimate dynamic flexural-tensile strength is the largest and is 1.49 in the impact test.(3)Compared with the static loading tests,the ultimate dynamic flexural-tensile strength increases,the ultimate dynamic flexural-tensile strains decrease a little,and the dynamic tensile Young's modulus increases a little,while the position of the neutral axis of normal section in pure bending part does not change in the impact tests.(4)Cyclic load has disadvantageous effect of low cycle fatigue.Comparative analysis of the dynamic flexural-tensile mechanical behavior of fully-graded concrete and wet sieving concrete shows that the relation is similar qualitatively and is not explicit in quantitate,so the dynamic test results of fully-graded concrete should be used in the seismic design of high arch dams.

Test Technique and Data Processing Method for Dynamic Flexural-Tensile Test of Concrete

Study on Flexural-Tensile Test Technique for Fully-Graded Concrete in Dynamic States

Flexural behavior of concrete-filled circular steel tubes under high-strain rate impact loading

RESEARCH ON FLEXURAL PERFORMANCE OF DOUBLE-STEEL REINFORCED CONCRETE BEAM

Flexural strength analysis of non-post-tensioned and post-tensioned concrete-filled circular steel tubes

Experimental Study on Fully-Graded Concrete in Static and Dynamic States Based on the Different Modulus Elasticity Theory

Experimental Study on Dynamic Flexural-Tensile Mechanical Behavior of Wet Sieving Concrete of Xiaowan Arch Dam

Flexural Behaviour of Reinforced Concrete Beams under Freeze–thaw Cycles and Sustained Load

Effect of Testing Method and Strain Rate on Stress-Strain Behavior of Concrete

Experimental study on dynamic flexural-tensile mechanical behavior of three-graded concrete in Xiaowan Arch Dam

Flexural-tensile testing of fully-graded concrete in static and dynamic states for high arch dam

FLEXURAL BEHAVIOUR OF THIN-WALLED DODECAGONAL SECTION DOUBLE SKIN CONCRETE-FILLED STEEL TUBES

Compressive Tests of Thin-Walled Circle Concrete-Filled Steel Tubes

Experimental study of strain rate effect on dynamic flexural-tensile properties of wet sieving concrete in Xiaowan arch dam

Test technique and data processing method for the dynamic bond behavior between steel bar and concrete under high stress rates

Tensile Strength of Concrete under Static and Intermediate Strain Rates: Correlated Results from Different Testing Methods

A new test method for the complete load-displacement curve of concrete under mixed mode I-II fracture

Tensile Fatigue Properties of Ordinary Plain Concrete and Reinforced Concrete under Flexural Loading

Dynamic Brazilian Test of Concrete Using Split Hopkinson Pressure Bar

Experimental Study of Size Effect on Static/Dynamic Flexural-Tensile Strength of Three-Graded Concrete

Experimental Study on Failure Mechanism of Flexural Reinforced Concrete Beams in Fatigue Load