Abstract:Introduction Shot peening (SP) is an important method to enhance metallic superficial properties [1-4]. After SP, the introduced compressive residual field (CRS) and change of microstructure could improve the surface properties significantly [5-7], such as surface microhardness, stress corrosion property, fatigue life, ect [8,9]. Stress peening is a special and important shot peening method. It is mainly used in stress peening forming to fabricate thin parts with complicated shapes, such as sheet with double curvatures, aerofoils. In the process of stress peening, specimens were elastically prebended in certain directions for peening forming. And a CRS field, a critical parameter for the component, were induced by high energy “shots”. After stress peening, the prestresses were released and the CRS field was changed by elastic recovery. This change could be considered as a superposition of two stress fields: one is a CRS field introduced by SP, another one is a stress field generated by release of the prestress. Specially, for different materials, the CRS field was different with same peening parameter and prestress [10-15]. Recently, the CNTs reinforced aluminium matrix composites have attracted wide and growing attentions to develop a new generation of high-stiffness metallic, high-strength, lightweight materials [16-22]. Due to it would be used for the fields of the electronic and military devices, high speed transportation. In these fields, the new material might be formed by stress peening to fabricate some complicated shapes. After stress peening, the CRS field induced by stress peening should be retained or released by annealing treatment due to specific requirements. In addition, few investigations have been made on thermal relaxation of an anisotropic CRS field.

Residual Stress and Its Relaxation Behavior of TC4-DT Titanium Alloy after Shot Peening

Residual Stress Field and Thermal Relaxation Behavior of Shot-Peened TC4-DT Titanium Alloy

The residual stress varying of shot peened TC4-DT titanium alloy

Influence of Shot-Peening Coverage on Surface Integrity of TC4 Titanium Alloy

Effect of the Conventional Shot Peening and Multiple Shot Peening on Microstructure and Residual Stress of TC17 Titanium Alloy

Effect of Shot Peening Strengthening on Microstructure and Properties of TC4-DT Titanium Alloy

Research Development of Shot Peening Strengthening of Titanium Alloys

Thermal Relaxation of Residual Stresses in Shot Peened Surface Layer on Tib2/Al Composite at Elevated Temperatures

Residual Stress Distribution And Microstructure Characterization Of Particle Reinforced Titanium Matrix Composite After Shot Peening Treatment: A Review

Thermal relaxation behavior of residual stress in laser hardened 17-4PH steel after shot peening treatment

Investigation on Experiments and Numerical Modelling of the Residual Stress Distribution in Deformed Surface Layer of Ti–6Al–4V after Shot Peening

Investigation of Wet Shot Peening on Microstructural Evolution and Tensile-Tensile Fatigue Properties of Ti-6Al-4V Alloy

Numerical Analysis and Experimental Validation on Residual Stress Distribution of Titanium Matrix Composite after Shot Peening Treatment

Characterization on Surface Mechanical Properties of Ti–6Al–4V after Shot Peening

Research on the water cavitation peening process and mechanism of TC4 titanium alloy

Thermal Relaxation of Residual Stress in Shot-Peened CNT/Al–Mg–Si Alloy Composites

Investigation on the Residual Stress and Microstructure of (tib+tic)/ti–6al–4v Composite after Shot Peening

Thermal relaxation of residual stress in a carbon nanotube reinforced aluminium matrix composite

Residual Stress Relaxation in Shot Peened Surface Layer on Tib2/Al Composite under Applied Loading

Research on stress relaxation behavior of TA15 titanium alloy

The evolution of residual stress and microstructure in shot peened s30432 austenitic stainless steel at high temperatures