Measurement of Strain Distribution and Matal Flow in Plastic Bulk Deformation

李峰,李莉,王香
DOI: https://doi.org/10.3969/j.issn.1006-7043.2009.08.024
2009-01-01
Abstract:A new screw method for strain measurement has been advanced to obtain strain distribution and metal flow line distribution inside a metal or plastic body experiencing deformation.The main advantage of this method is that it can be used to analyze 3D deformation behaviour without requiring a substitute material and can give quantitative results.Using this method,four typical flow lines,axial strain and radial strain were measured when forming a complex steel hub.A quantitative measurement of strain distribution was obtained.This method is an effective technique for analysis of metal deformation behaviour during die forging.It can be used to study material flow and to predict strain distribution in general bulk metal forming processes such as upsetting,extrusion,and so on.
What problem does this paper attempt to address?