Abstract:The utilization of neutralization slag from a lead zinc smelting wastewater was investigated to prepare unburned and non autoclaved bricks .On the basis of analysis of main chemical components ,XRD phase analysis and neutralization slag digestion and drying condensation performance analysis .Orthogonal experiment of L16 (4)5 was designed to study the effect of different brick compositions on the strength of 7 d and 28 d of unburned and non autoclaved bricks and the optimum recipe preparation of brick was obtained through the analysis of range and variance ,and the relationship between the molding pressure an d water cement ratio and the properties of unburned an d non autoclaved brick was studied under the optimum formula .The result shows that the factors influencing the 7 d compressive strength of the unburned an d non autoclaved brick were amount of cement ,amount of water slag powder ,amount of mix neutralization slag , amount of fly ash and amount of stone chip in order .The factors influencing the 28 d compressive strength of unburned and non autoclaved brick were amount of mixed neutralization slag ,amount of water slag powder ,amount of stone chip ,amount of fly ash and amount of cement in order .The best experiment formula was 31 .43％ mixed neutralization slag ,14 .29％ cement ,31 .43％ water slag micropowder ,13 .33％fly ash ,9 .52％ stone chip ;the best of the ratio of water to cement is 0 .14 ,molding pressure is 20 MPa . Finally ,the 28 d compressive strength of unburned and non autoclaved brick was 27 .7 MPa ,water absorption was 11 .5％ ,softening coefficient was 0 .89 and frost resistance index was F25 ,which reached the requirement of JC422-2007non sintered waste tailings unburned brick .

Study on the Preparation Technology of Brick with Phosphogypsum Pretreated by Steam and Its Strength Mechanism

Preparation of Load-Bearing Building Materials from Autoclaved Phosphogypsum

Mechanical Performance of the Phosphogypsum Baking-free Bricks

Study on Preparation of Decarburized Fly Ash-phosphogypsum Autoclaved Brick

Utilization of waste phosphogypsum to prepare non-fired bricks by a novel Hydration–Recrystallization process

Study on the Pretreatment Technology of High-strength Gypsum with Phosphogypsum

Experimental study on utilization FGD byproducts in building bricks

Synthesis of High-Strength and Water-Resistant Phosphogypsum Small Hollow Block

Preparation of High-Strength Building Block with Phosphogypsum

Research on the pretreatment and mechanical performance of undisturbed phosphogypsum

Analysis on Compressive and Flexural Strength of Unburned Brick with Electrolytic Manganese Slag

New dawn of solid waste resource treatment: Preparation of high-performance building materials from waste-gypsum by mechanical technology

Study on Preparation of Bricks with Volcanic Rock and Its Performances

Experimental Study on Preparation of Non-burnt Brick from Electrolytic Manganese Residue

The use of phosphogypsum for soil bricks manufacturing as an alternative for its sustainable destination

Preparation of High Strength Bricks Without Firing and Autoclaving

Experimental study on preparation of unburned and non autoclaved brick from neutralization slag of lead zinc smelting wastewater

Preparation and Strength Property of Autoclaved Bricks from Electrolytic Manganese Residue

Study on enhancing mechanism of phosphogypsum construction material with high strength

Influence Of Autoclaved Pretreatment On The Properties Of Phosphogypsum-Based Composite Binders

Study on Preparation of the Renewable Soil-Cement Slag Bricks and Their Properties