Abstract:The coal mine power supply and distribution system usually adopts the neutral point non-effectively grounded method. Most of the power supply lines in this method use cable lines. The underground power supply system is complex and uses many voltage levels. When a single-phase to ground fault occurs, it is easy to form intermittent arcs at the grounding point. Moreover, the existing single-phase to ground fault arc suppression technology of the neutral point non-effectively grounded distribution network has the problem of poor arc suppression effect and difficulty in accurately measuring the parameters of the distribution network to the ground. The most common connection method of transformer winding in 10 kV substation of coal mine in China is delta connection. This mode needs to lead out neutral point and connect arc suppression coil artificially through special grounding transformer (mostly Z-type grounding transformer). In order to solve the above problems, a flexible arc suppression system for single-phase to ground fault of distribution network based on Z-type grounding transformer is designed. When the initial time of grounding fault occurs in the distribution network, the three-phase power supply electromotive force and the neutral point voltage of the power distribution network are firstly measured in real time. When the amplitude of the neutral point voltage is greater than 15% of the three-phase power supply electromotive force, it can be judged as a grounding fault. Compared with the three-phase power supply electromotive force, the phase with the smallest power supply electromotive force is the fault phase. After a single-phase to ground fault occurs, the fast switching switch corresponding to the fault phase is quickly closed. And the active inverter and the Z-type grounding transformer power conversion module are simultaneously put into operation. The Z-type grounding transformer power conversion module clamps the voltage of a neutral point in an opposite phase to be close to the electromotive force of the fault phase power supply. And the amplitude and the phase of the difference between the neutral voltage and the fault phase supply voltage are precisely compensated by the active inverter. Therefore, the control target of suppressing the voltage and the current at the fault point to zero is achieved. After a certain time delay, the fast switching switch is cut off. If the voltage of the neutral point is effectively reduced, it can be judged that the fault is a transient ground fault. And the normal operation of the power distribution network system can be restored. Otherwise, it is judged as a permanent fault. The measures to isolate the fault feeder are taken to restore the normal operation of the distribution network. The simulation results show that when the single-phase to ground fault transition resistance is 500 Ω and 3 000 Ω, the power conversion is only through the Z-type grounding transformer. The voltage and current suppression rate at the fault point reaches 79%-83%, which cannot fully achieve the effect of arc suppression. The flexible arc suppression system can effectively suppress the voltage and current at the fault point, with a suppression rate of more than 98%, realizing reliable arc suppression of single-phase to ground faults in the distribution network.

Experimental Study on Extinguishing Arc Performance in Different Types of Arc Suppressioni Coils

Research on the Resonance Over-Voltage of Power Distribution Network with Different Arc Suppression Coil

An improved method for arc suppression coil tuning during single-phase to earth fault

Study on a New Resonant Grounding System

Experimental Study on the Extinction Characteristics of Secondary Arc Under Different Secondary Arc Currents Near Outdoor Insulator

A New Method of Active Arc Suppression for Single-Phase Grounding Fault in Distribution Network and Its Influencing Factors

DC Arc Self-Extinction and Dynamic Arc Model in Open-Space Condition Using a Yacob Ladder

Application and Preference of the Arc-extinguishing Coil in Electric Power System

Research on the Arcing Horn with Active Arc Extinguishing Function for HVDC Grounding Electrode Line

Research of neutral grounding modes for 20kV distribution network

Research of Neutral Grounding Modes for 20 Kv Distribution Network

A Non-neutral alternate arc suppression method for single phase grounding fault in active distribution network

DC Arc Numerical Calculations and Experimental Researches Based on the Arcing Horn Used in Over-head Line

Dynamic physical characteristics of DC arc on arcing horn for HVDC grounding electrode line

NEW TYPE OF ARC SUPPRESSION COIL BASED ON SYMMETRY AND PHASE TUNING PRINCIPLE

High Voltage Simulation Grid for Performance Study on Arc Suppressing Coil

Flexible arc suppression method for single-phase to ground fault in distribution network based on Z-type grounding transformer

A New Principle of Active Arc Suppression for Distribution Network Based on Constant Fault Phase Current

Study on the Arc Motion Characteristics of Multi-Chamber Arrester Based on 3D Model.

Performance and Characteristics of a Small-Current DC Arc in a Short Air Gap

Experimental Study of Breaking Arc Characteristics for DC Miniature Circuit Breaker