Abstract:This paper presents an experimentally validated control-oriented model and an observer for diesel oxidation catalyst (DOC)-diesel particulate filter (DPF) system in the context of exhaust gas NO and NO2 concentration estimations. NO and NO2 have different reaction characteristics within DPF and selective catalytic reduction (SCR) systems, two most promising diesel engine aftertreatment systems. Although the majority of diesel engine-out NOx emissions is NO, the commonly used DOC located upstream of a DPF and a SCR can convert a considerable amount of NO to NO2. Knowledge of the NO/NO2 ratio in exhaust gas is thus meaningful for the control and diagnosis of DPF and SCR systems. Existing onboard NOx sensors cannot differentiate NO and NO2, and such a sensory deficiency makes separate considerations of NO and NO2 in SCR control design challenging. To tackle this problem, a control-oriented dynamic model, which can capture the main NO and NO2 dynamics from engine-out, through DOC, and to DPF, was developed. Due to the computational limitation concerns, DOC and DPF are assumed to be standard continuously stirred tank reactors in order to obtain a 0D ordinary differential equation model. Based on the model, an observer, with the measurement from a commercially available NOx sensor, was designed to estimate the NO and NO2 concentrations in the exhaust gas along the aftertreatment systems. The stability of the observer was shown through a Lyapunov analysis assisted by insight into the system characteristics. The control-oriented model and the observer were validated with engine experimental data and the measured NO/NO2 concentrations by a Horiba gas analyzer. Experimental results show that the model can accurately predict the main engine-out/DOC/DPF NO/NO2 dynamics very well in semisteady-state tests. For the proposed observer, the predictions converge to the model values and estimate the NO and NO2 concentrations in the aftertreatment system well.

A Precise Estimation of Intake Port Air Mass Flow in SI Engines Based on State-Observer

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

Torque Observers Design for Spark Ignition Engines with Different Intake Air Measurement Sensors

A Numerical Study into the Importance of Equivalence Ratio Measurement Accuracy for Spark Ignition Engines

Simulation and Experimental Study of EFI Gasoline Engine's Manifold Filling Dynamic Model

Engine mass airflow sensor fault detection via an adaptive oxygen fraction observer

In-cylinder air mass flow estimation of gasoline engines based on map self-learning

Adaptive Sliding Mode Observer for Updating Maps with an Application to Mass Air Flow Sensors in Diesel Engines

Input Observer-Based Individual Cylinder Air-Fuel Ratio Control: Modelling, Design and Validation.

Adaptive and Learning Control for SI Engine Model With Uncertainties

Numerical computed methods for intake manifolds in gasoline engine

Nonlinear observer-based exhaust manifold pressure estimation and fault detection for gasoline engines with exhaust gas recirculation

Air-Fuel Ratio Control for Gasoline Engines Based on Physical Model Assisted Extended State Predictive Observer

Model-Based Precise Air-Fuel Ratio Control for Gaseous Fueled Engines

A Lpv Adaptive Observer Approach To Calibrate Maf Sensor Map In Diesel Engine

Simultaneous estimation of ammonia injection rate and state of diesel urea-SCR system based on high gain observer

NO and NO2 Concentration Modeling and Observer-Based Estimation Across a Diesel Engine Aftertreatment System

Study of Engine Performance Monitoring Based on Observer Model

The Research and Simulation on Flow Characteristic of Variable Intake System of Motorcycle Engine

Study on Intake Pressure Feedback Control with Model-Based Feedforward

Estimation of Individual Cylinder Air-Fuel Ratio in Gasoline Engine with Output Delay.