Abstract:The smart diesel program requires the engine electronic control unit to consider additional parameters, such as altitude and climatic conditions, in the mapping calibration process. A specially designed environmental simulation cabin, which can simulate environmental conditions at any longitude and dimension, would allow dynamometer testing to be performed indoors. Considering its high cost, a three-dimensional (3D) computational fluid dynamics (CFD) is needed to guide and/or complement experimental researches. As a result, the main objective of this study was to establish a 3D RANS model (i.e., reasonable computational cost and running time) that can provide in-cylinder details and predict the efficiency of a 6V150 diesel engine under varied operating conditions. A sector mesh approach was employed, considering only the compression, combustion, and expansion periods from intake valve closing to exhaust valve opening. The results indicated that the model simulated cylinder pressure agreed well with the experimental data, with relative errors of less than 6% during the primary compression, combustion, and expansion. Further, the model predicted heat release phasing was inconsistent with the experimental results, with absolute errors of less than one crank angle degree for peak pressure location, CA50, and ignition delay. In addition, the multidimensional model captured the effects of environmental pressure and temperature on spray formation (i.e., the dominant phenomenological event). Moreover, the model reasonably reproduced the effects of engine control variables on performance and emissions. All these observations demonstrated the validity of the selection and calibration of geometry, chemistry, and submodels including turbulence, spray, heat transfer, combustion, etc. Overall, the model was deemed capable of predicting combustion characteristics under extreme conditions, including high-temperature, high-cold, and high-altitude environments, which can facilitate the development of smart engines.

Simulation and Experimental Study of EFI Gasoline Engine's Manifold Filling Dynamic Model

Optimization of Gasoline Engine Intake System Based on 1D, 3D and Coupled Simulations

Fuel Injection System Simulation for DME Engine

Multidimensional Computational Fluid Dynamics Combustion Process Modeling of a 6V150 Diesel Engine

Three-Dimensional Computational Fluid Dynamics Modeling of a 6V150 Diesel Engine

Numerical computed methods for intake manifolds in gasoline engine

An Experimental Study on Engine Dynamics Model Based In-Cylinder Pressure Estimation

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

An Advanced High Dimensional Model Representation Approach for Internal Combustion Engine Modeling and Optimization

Effects of Intake Manifold on Volume Efficiency of EFI Gasoline Engines

A Numerical Study into the Importance of Equivalence Ratio Measurement Accuracy for Spark Ignition Engines

Three-Dimensional Computational Fluid Dynamics Modeling of the Combustion Process of a MAN L21/31 Marine Diesel Engine

Numerical simulation of direct injection gasoline engine model

Modeling and Simulation of Electronic Unit Pump Diesel Engine

Combustion model development of future DI engines for carbon emission reduction

Development of Real-time Simulation System for Gasoline Engine Based on Engine Model and Road Test Data

Simulation Modeling Method and Experimental Investigation on the Uniflow Scavenging System of an Opposed-Piston Folded-Cranktrain Diesel Engine

A Precise Estimation of Intake Port Air Mass Flow in SI Engines Based on State-Observer

Structure Optimization of Natural Gas Engine’s Intake Pipe Based on One-Dimensional and Three-Dimensional Coupled Simulation

Study on Modeling and Simulation of a Flight Simulator Engine System

A Mean Value Model for Gasoline Engine and its Usage in Hardware-in-the-Loop Simulation