Abstract:The internal combustion engine will continue to be the primary source of power for transportation. Spark ignition (SI) engines are still widely used for mobility due to their wide range of operating conditions. The key operating variables of an engine are primarily controlled by an engine control unit that has been calibrated. However, a less accurate sensor can lead to large variations in engine performance and emissions. The purpose of this study was to investigate the importance of air-fuel ratio sensor precision during operation of various engines. In this study, a one-dimensional (1D) computational fluid dynamics (CFD) model was used to analyze the engine response due to the variation of the equivalence ratio sensor precision at different engine speeds and loads, to explore the main indicators influenced by the precision of equivalence ratio measurements, and to propose a discriminant criterion for evaluating the suitability of the proposed equivalence ratio precision in relation to the conversion rate of three-way catalyst and vehicle emissions. The results show that for engine performance, it varies slightly with small changes in the fuel-to-air ratio. At higher engine speeds, a slight change in the air-fuel ratio leads to a smaller change in emissions. At the same time, changes in fuel-to-air ratio have a significant effect on carbon monoxide (CO) and nitrogen oxides (NOx) emissions. Carbon monoxide is the most sensitive to the air-fuel ratio, followed by nitrogen oxides, while unburned hydrocarbons are not sensitive to it. And for the three measurement accuracies studied in this paper (0.5%, 1%, and 2%), the accuracies are acceptable, but combining the relative errors of the actual emissions of CO and in order to achieve accurate combustion control, it is recommended that the sensor accuracy should be at least higher than 1% for the port fuel injected engine investigated in this study.

Air-Fuel Ratio Control for Gasoline Engines Based on Physical Model Assisted Extended State Predictive Observer

Disturbance Rejection Control of Air–fuel Ratio with Transport-Delay in Engines

Multiple Model Predictive Control for Oxygen Starvation Prevention of Fuel Cell System

Model Prediction Control of Fuel-Air Ratio for Lean-Burn Spark Ignition Gasoline Engine

Model-Based Precise Air-Fuel Ratio Control for Gaseous Fueled Engines

ADRC with Adaptive Extended State Observer and Its Application to Air–Fuel Ratio Control in Gasoline Engines

ESO-based Robust Predictive Control of Lunar Module with Fuel Sloshing Dynamics

Input Observer-Based Individual Cylinder Air-Fuel Ratio Control: Modelling, Design and Validation.

Stochastic Air-Fuel Ratio Control of Compressed Natural Gas Engines Using State Observer

Design of Active Fault-Tolerant Control System for Air-Fuel Ratio control of Internal Combustion engine using nonlinear regression-based observer model

Engine mass airflow sensor fault detection via an adaptive oxygen fraction observer

Adaptive and Learning Control for SI Engine Model With Uncertainties

ESO-based robust adaptive control for dual closed-loop fuel control system in aeroengine

In-cylinder air mass flow estimation of gasoline engines based on map self-learning

Sensor selection and controller design method with application to turbocharged stoichiometric spark-ignited engine controls with low pressure EGR

Numerical Investigation of the Fuel/Air Ratio Sensor Sensitivity in a Port-Fuel-Injected Spark-Ignition Engine Equipped with Three-Way Catalysts

Nonlinear control approaches for SI engine model with uncertainties

On Error-Driven Nonlinear ESO Based Control Design with Application to Air–fuel Ratio Control of Engines

Improved Scheme of Membership Function Optimisation for Fuzzy Air‐fuel Ratio Control of GDI Engines

MODEL BASED AIR-FUEL RATIO CONTROL FOR PFI SI ENGINES FUELED WITH ETHANOL-GASOLINE BLENDS

Fault-Tolerant Control Based on Set-Membership Estimation for Linear Discrete-Time Systems With Parameter Uncertainties and Application to Aero-Engine Control System