Abstract:The effect of charge stratification by direct, in-cylinder injection of a small quantity of propane-air mixture in a single-cylinder, propane-fuelled, spart-ignition engine, has been determined in terms of in-cylinder pressure, flame visualisation and exhaust emissions. The operating conditions ranged from low load to wide open throttle at 1000 and 1500 rpm, and with quiescent and swirling in-cylinder flows. The effects of injection-driven flow and turbulence on combustion have been considered independently of mixture strength by assessing the consequences of injecting a local mixture of an equivalence ratio equal to that of the port-induced charge. The results provide further evidence to support the concept of direct in-cylinder mixture injection. At 1000 rpm and low load, faster development of the flame kernel and subsequent enflamed area were observed, together with a 60% increase in peak cylinder combustion pressure at an overall equivalence ratio of 0.7 ( A / F of 22.5). The relative effect of local-charge stratification increased with reduction in equivalence ratio at this engine speed and without increase in emissions; at 1500 rpm, stable combustion was achieved even at an equivalence ratio of 0.61 ( A / F of 25.8), which was below the flammability limit of the homogeneous port-only propane/ air mixture. Unthrottled engine operation produced similar results so that at an equivalence ratio of 0.55 ( A / F of 28.5), for example, the Coefficient of variation of the indicated mean effective pressure was reduced from 0.4 to less than 0.1 by mixture local injection. With a shrouded inlet valve generating mean gas velocities of 6 m/s at the time of ignition in the vicinity of the spark plug, control of rich mixture injection both with and against the bulk in-cylinder flow, resulted in stable combustion with Coefficient of variation of the indicated mean effective pressure of less than 0.1 at an equivalence ratio of 0.55 ( A / F of 28.5).

In-Cylinder Mixture Distribution of Direct Injection LPG Using Laser-Induced Fluorescence

In-Cylinder Mixture Distribution Research of Stratified Lean-Burn Strategy and Stratified Stoichiometric Strategy in a GDI Engine Using Laser-Induced Fluorescence

In-Cylinder Mixture Distribution Measurement in a GDI Engine Using Laser-Induced Fluorescence

Co-evaporative multi-component fuel design for in-cylinder PLIF measurement and application in gasoline direct injection research

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Experimental Investigation of Low-Temperature Autoignition in Turbulent Premixed Swirling Flames

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

Effect of Ignition Advance Angle on Liquid Phase LPG Injection Engine Performance

Local Mixture Injection to Extend the Lean Limit of Spark-Ignition Engines

Influence of Ignition Advance Angle on LPG Engine

Experimental Studies on the Combustion Characteristics and Performance of a Naturally Aspirated, Direct Injection Engine Fuelled with a Liquid Petroleum Gas/diesel Blend

Nonuniform Mixture Formation by a Two-Stage Gasoline Direct Injection Combustion System

High-Speed Photography of Stratified Combustion in an Optical GDI Engine for Different Triple Injection Strategies

Characterization of Mixture Formation Processes in DI Gasoline Engine Sprays with Split Injection Strategy Via Laser Absorption and Scattering (LAS) Technique

Numerical Investigations of Injection Timing Effects on a Gasoline Direct Injection Engine Performance: Part A, In-Cylinder Combustion Process

Effect of Split Injection on Stratified Charge Formation of Direct Injection Spark Ignition Engines

Quantitative mixing measurements and stochastic variability of a vaporizing gasoline direct-injection spray

Influence of Swirl Ratio on Fuel Distribution and Cyclic Variation under Flash Boiling Conditions in a Spark Ignition Direct Injection Gasoline Engine

Effect of Injection Modes on Direct Injection Gasoline Stratified Combustion

Characterization of Split Injection D.I. Gasoline Spray : 1st Report: LAS Measurement of Mixture Distribution

Characterization of Mixture Formation Processes in D.I. Gasoline Sprays by the Laser Absorption Scattering (LAS) Technique - Effect of Injection Conditions