Effect of several factors on quick-point grinding surface roughness

Jian Qiu,Yadong Gong,Changfu Liu,Ye Zhang
DOI: https://doi.org/10.3969/j.issn.1006-852X.2009.04.008
2009-01-01
Abstract:This study discussed several influencing factors on surface roughness and machining precision in quick-point grinding. It is found that the surface roughness influenced by wheel speed and grinding depth can be attributed to the changing of undeformed chip thickness. The ideal roughness can be obtained by reducing grinding inclined angle which reduced undeformed chip thickness. Increasing grinding depth and axial feed rate can improve material removal rate, but at the same lime, the roughness is deteriorated, which is possibly caused by the decrease of the number of active grains. By controlling the inclined angle to enlarge the number of active grains,a higher material removal rate is guaranteed,and a better grinding surface is obtained- In addition, the contact times of grains and peaks of workpiece surface profile are increased by increasing the times of spark out and using inclined wheel, which is helpful to decrease the surface roughness.
What problem does this paper attempt to address?