Abstract:With the rapid development of precision technologies, the demand of high-precision optical surfaces has drastically increased. These optical surfaces are mainly fabricated with computer controlled optical surfacing (CCOS). In a CCOS process, a target surface removal profile is achieved by scheduling the dwell time for a set of machine tools. The optimized dwell time should be positive and smooth to ensure convergence to the target while considering CNC dynamics. The total run time of each machine tool is also expected to be balanced to improve the overall processing efficiency. In the past few decades, dwell time optimization for a single machine tool has been extensively developed. While the methods are applicable to multi-tool scenarios, they fail to consider the overall contributions of multiple tools simultaneously. In this paper, we conduct a systematic study on the strategies for multi-tool dwell time optimization and propose an innovative method for simultaneously scheduling dwell time for multiple tools for the first time. First, the influential factors to the positiveness and smoothness of dwell time solutions for a single machine tool are analyzed. The compensation strategies that minimize the residual while considering the CNC dynamics limit are then proposed. Afterwards, these strategies are extended to the proposed multi-tool optimization that further balances the run time of machine tools. Finally, the superiority of each strategy is carefully studied via simulation and experiment. The experiment is performed by bonnet polishing a 60 mm x 60 mm mirror with three tools of different diameters (i.e., 12 mm, 8 mm, and 5 mm). The figure error of the mirror is reduced from 45.42 nm to 11.18 nm root mean square in 13.28 min. Moreover, the measured polishing result well coincides with the estimation, which proves the effectiveness of the proposed method. (C) 2022 Optica Publishing Group under the terms of the Optica Open Access Publishing Agreement

Optimization of Removal Function Parameters in CCOS

Research on Computer Controlled Optical Surfacing (CCOS) Working Function at Wear State

The flexible optical manufacturing technologies for large aspheric mirror

Dwell Time Algorithm for Multi-Mode Optimization in Manufacturing Large Optical Mirrors

Edge Control in the Computer-Controlled Optical Surface

Optimization of the Morphology of the Removal Function for Rotating Abrasive Water Jet Polishing

Adjustment on the Received Optical Power of a Ground-Based Optical Instrument by a Corner Cube Retroreflector with a Curved Front-Face.

Multi-tool optimization for computer controlled optical surfacing

Research and application on the key techniques of conformal vibration polishing on optics

Air Flow Turbulence Orthogonality and Surface Error Estimation in Large Aperture Optical Testing

Toward the Accurate Coverage of Aspheric Surfaces Using Two-Dimensional Scanning Paths for Minimizing Regular Errors

Universal dwell time optimization for deterministic optics fabrication

Integration of Metrology in Grinding and Polishing Processes for Rotationally Symmetrical Aspherical Surfaces with Optimized Material Removal Functions

Influence of motion modes on surface quality in CCOS

Increasing the efficiency of CCOS by local deconvolution algorithm

Removal Character of Vertical Jet Polishing with Eccentric Rotation Motion Using Magnetorheological Fluid

Computer-controlled Compensation for Wearing of Polishing Head

Statistical Tool Size Study for Computer-Controlled Optical Surfacing

Tilt angle correction based forming algorithm for high steepness aspheric surfaces polishing

Correcting the Accuracy of Non-Rotating and Aspheric Lens by Controlling the Pressure of the Polishing Die

Tool path optimal design for slow tool servo turning of complex optical surface